Water-wall furnaces transfer heat to the water circuits primarily via _________________?
Show answer Hide answer
Answer: B. radiation
Explanation
Water-wall furnaces transfer heat primarily via high-intensity radiation. Radiant energy from the burning fuel directly heats the water-filled tubes. Furnace design maximizes radiant heat absorption in modern steam generators. Radiation is the transfer of thermal energy via electromagnetic waves. Water walls line the combustion chamber to protect refractory and generate steam. Boiler efficiency depends heavily on effective radiant heat transfer rates.
Power plant boilers utilize water walls to maximize steam production capacity. Thermal engineering principles dictate the selection of furnace heating surfaces. Efficient heat absorption reduces the required fuel input for power generation. Convection plays a secondary role compared to intense furnace radiation. Conduction occurs through the metal tube walls rather than across the furnace. Combined radiation and conduction does not represent the primary transfer mode.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. At maximum output, petrol engine exhaust contains CO percentages on the order of____________________?
Show answer Hide answer
Answer: D. Considerable percent
At maximum output power, petrol engines operate on rich air fuel mixtures. Insufficient oxygen during rich combustion prevents complete fuel oxidation, producing carbon monoxide. Exhaust gas analysis during full throttle...
Q2. Diesel engine turbulence chambers operate by__________________?
Show answer Hide answer
Answer: B. fuel is injected into an auxiliary chamber that is separated from the cylinder by an orifice or throat
Diesel turbulence chambers use an auxiliary pre-chamber connected to the main cylinder by a narrow throat. Fuel is injected into this auxiliary chamber where rapid air swirl promotes thorough mixing and initial combustio...
Q3. Diesel engine precombustion chambers function via________________?
Show answer Hide answer
Answer: C. Only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency mixes thoroughly into main cylinder charge
Precombustion chambers are small auxiliary spaces connected to the main cylinder through a narrow throttling orifice. Fuel is injected directly into this auxiliary chamber where partial combustion rapidly consumes the av...
Q4. Injection lag represents_________________?
Show answer Hide answer
Answer: B. time before actual fuel injection and the pump pluger starts to pump fuel
Injection lag measures the mechanical delay before actual fuel injection begins in the engine. The pump plunger must travel and build sufficient hydraulic pressure to lift the injector valve. This interval occurs between...
Q5. Free vortex motion is characterized by a radial velocity component everywhere equal to________________?
Show answer Hide answer
Answer: C. zero
Free vortex motion is characterized by irrotational fluid flow where fluid particles follow concentric circular paths. In an ideal free vortex, fluid moves tangentially while having no radial velocity component whatsoeve...
Q6. Rotating a drum of radius R filled with fluid of density p at angular velocity corad/sec increases outer edge pressure by___________________?
Show answer Hide answer
Answer: B. pco2/?2/2
Rotating a fluid-filled drum creates a forced vortex where the pressure rise at the outer edge is proportional to the square of angular velocity and radius.