Injection lag represents_________________?
Show answer Hide answer
Answer: B. time before actual fuel injection and the pump pluger starts to pump fuel
Explanation
Injection lag measures the mechanical delay before actual fuel injection begins in the engine. The pump plunger must travel and build sufficient hydraulic pressure to lift the injector valve. This interval occurs between the pump stroke start and the actual entry of fuel into the cylinder. Fuel injection systems require precise timing to ensure optimal engine performance and efficiency. High pressure lines connect the injection pump to the nozzle, creating slight fluid compression delays. Mechanical wear or trapped air bubbles can increase injection lag and disrupt engine timing.
Diesel engine mechanics must adjust injection timing to compensate for mechanical lag intervals. Excessive lag leads to delayed combustion, rough idling, and reduced overall engine power output. Modern electronic fuel injection minimizes physical delays compared to traditional mechanical pump systems. Ignition delay refers to the time after fuel injection before autoignition temperatures are reached. Top dead center represents piston position rather than the mechanical timing of pump plungers. Ignition timing lag involves combustion reactions rather than pump plunger movement mechanics.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Diesel engine precombustion chambers function via________________?
Show answer Hide answer
Answer: C. Only a part of air charge is contained in an auxiliary chamber in which the fuel starts to burn with insufficient air which due to explosion tendency mixes thoroughly into main cylinder charge
Precombustion chambers are small auxiliary spaces connected to the main cylinder through a narrow throttling orifice. Fuel is injected directly into this auxiliary chamber where partial combustion rapidly consumes the av...
Q2. Preventing knock in spark-ignition engines requires unburned end-gas away from the spark plug to possess___________________?
Show answer Hide answer
Answer: E. all of the above
Knock occurs when unburned end-gases auto-ignite prematurely ahead of the normal flame front propagation. Low end-gas temperatures and low densities delay spontaneous auto-ignition reactions effectively. Long ignition de...
Q3. Water-wall furnaces transfer heat to the water circuits primarily via _________________?
Show answer Hide answer
Answer: B. radiation
Water-wall furnaces transfer heat primarily via high-intensity radiation. Radiant energy from the burning fuel directly heats the water-filled tubes. Furnace design maximizes radiant heat absorption in modern steam gener...
Q4. Rotating a drum of radius R filled with fluid of density p at angular velocity corad/sec increases outer edge pressure by___________________?
Show answer Hide answer
Answer: B. pco2/?2/2
Rotating a fluid-filled drum creates a forced vortex where the pressure rise at the outer edge is proportional to the square of angular velocity and radius.
Q5. Creep considerations become significant in which application_________________?
Show answer Hide answer
Answer: D. gas turbine blades
Gas turbine blades operate in extreme environments under high centrifugal stresses at very elevated operating temperatures. Constant high temperatures cause metallic crystalline structures to slowly deform under sustaine...
Q6. Fluid flow between two pipeline locations requires a differential pressure exceeding what threshold_______________?
Show answer Hide answer
Answer: D. all of the above
Fluid flow through any closed pipeline encounters continuous resistance from internal pipe wall friction. Fluid viscosity creates internal shear stresses that resist directional movement along the pipe length. Overcoming...