Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57403

What volume of air is needed to burn 1 liter of fuel in a four-stroke engine_______________?

Select your answer for: What volume of air is needed to burn 1 liter of fuel in a four-stroke engine_______________?
Show answer

Answer: D. 9-10 m3

Explanation

Stoichiometric calculations dictate that hydrocarbon liquid fuels require massive volumetric quantities of atmospheric oxygen. Burning one single liter of typical fuel oil demands roughly nine to ten cubic meters of air. This substantial air requirement highlights why internal combustion engines need efficient forced induction or large displacement. Air is composed primarily of nitrogen with roughly twenty-one percent oxygen available to support combustion reactions. Internal combustion engines ingest large volumes of ambient air to ensure complete fuel oxidation and power generation. Mass air flow sensors measure incoming air volumes to help engine control units calculate proper fuel delivery.

Lower air volumes like one cubic meter would cause extreme oxygen starvation and massive black smoke emissions. Values around five cubic meters remain insufficient for complete combustion in standard four-stroke engine designs. Excessively high volumetric estimates exceeding eighteen cubic meters would yield overly lean, non-combustible mixtures.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. A four-stroke internal combustion engine running at 1500 rpm drives its camshaft at__________________?

Select your answer for: A four-stroke internal combustion engine running at 1500 rpm drives its camshaft at__________________?
Show answer

Answer: B. 750 rpm

A four-stroke engine completes one power cycle every two full crankshaft revolutions. Its camshaft must open and close valves at half the frequency of the rotating crankshaft. Dividing the 1500 rpm crankshaft speed by tw...

Q2. Diesel engine knock is primarily caused by____________________?

Select your answer for: Diesel engine knock is primarily caused by____________________?
Show answer

Answer: A. instantaneous and rapid burning of the first part of the charge

Diesel knock is caused by rapid auto-ignition of accumulated fuel built up during the ignition delay. A large mass of fuel injected during the delay period burns almost instantaneously, causing sharp pressure spikes. Thi...

Q3. Compared to a clean filter, a suction-carbureted petrol engine operating with a dirty air filter experiences an air-fuel ratio that is________________?

Select your answer for: Compared to a clean filter, a suction-carbureted petrol engine operating with a dirty air filter experiences an air-fuel ratio that is________________?
Show answer

Answer: A. higher

A dirty air filter restricts airflow into the engine, creating a higher vacuum in the intake manifold. This increased restriction reduces the mass of air entering the cylinder while fuel delivery remains relatively const...

Q4. Diesel engine output can be boosted without enlarging engine dimensions or speed by_________________?

Select your answer for: Diesel engine output can be boosted without enlarging engine dimensions or speed by_________________?
Show answer

Answer: E. supercharging

Supercharging increases the mass of air inducted into the cylinder during each intake stroke. This extra oxygen allows more fuel to be injected and burned without enlarging engine dimensions. Engine output is successfull...

Q5. Compression stroke end-pressures and temperatures in petrol engines are on the order of___________________?

Select your answer for: Compression stroke end-pressures and temperatures in petrol engines are on the order of___________________?
Show answer

Answer: B. 6 – 12 kg/cm2 and 250 – 350°C

Compression pressures and temperatures in petrol engines reach 6 to 12 kg/cm squared and 250 to 350°C. Keeping temperatures below auto-ignition limits prevents premature detonation or knock in spark-ignition engines. Mod...

Q6. Compression pressures at the end of the stroke in diesel engines typically reach___________________?

Select your answer for: Compression pressures at the end of the stroke in diesel engines typically reach___________________?
Show answer

Answer: E. 35 kg/cm

Diesel engines employ high compression ratios to heat compressed air sufficiently for spontaneous fuel ignition. At the end of the compression stroke, cylinder pressures typically reach approximately 35 kg/cm squared. Th...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test