Water injection is integrated into gas turbine cycles in order to___________________?
Show answer Hide answer
Answer: B. control output of turbine
Explanation
Water injection into gas turbines is utilized to increase mass flow and control or boost the power output of the turbine. Injecting liquid water into the combustion chamber or compressor discharge causes it to flash into high-pressure steam. This added mass flow expands through the turbine section, significantly increasing torque and short-term peak power generation. Water injection methods include steam generation and direct liquid water spraying into the compressor or combustor casing. The high latent heat of vaporization of water provides a strong cooling effect that reduces peak combustion temperatures. Lower combustion temperatures effectively suppress the formation of harmful nitrogen oxide emissions during heavy load operation.
Controlling fire hazards is managed through dedicated safety suppression systems rather than routine turbine water injection. Increasing efficiency is not the primary goal, as the latent heat loss can sometimes cause a minor penalty in thermal efficiency. Claiming that water injection is never done ignores established gas turbine power augmentation and emission control practices.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. What is the volumetric efficiency of a clearance-free compressor________________?
Show answer Hide answer
Answer: C. is not dependent upon compressin ratio
In a theoretical clearance-free compressor all trapped air is expelled during the discharge stroke completely. This complete expulsion eliminates the re-expansion of residual clearance gases during the subsequent intake...
Q2. What characterizes the volumetric efficiency of a compressor possessing clearance volume ________________?
Show answer Hide answer
Answer: B. decreases with increase in compression ratio
Clearance volume traps high-pressure gas that must expand during the suction stroke before fresh air can enter. As compression ratios increase, more of the stroke is wasted re-expanding the trapped clearance gas. This re...
Q3. The circulating working medium utilized within closed air turbines is___________________?
Show answer Hide answer
Answer: C. in a single phase
Closed-cycle air turbines rely on a working fluid that stays in a gaseous phase throughout operation. Air does not undergo phase change inside the closed loop of this specific thermodynamic power cycle. Maintaining a sin...
Q4. Engine connecting rods are predominantly fabricated from_________________?
Show answer Hide answer
Answer: C. medium carbon steel
Engine connecting rods require high tensile strength and toughness, typically achieved using medium carbon steels. Medium carbon steels provide an optimal balance of ductility, hardness, and fatigue resistance under load...
Q5. How does specific output per kg mass flow in a gas turbine (assuming fixed component efficiencies and temperature limits) respond to increasing pressure ratios___________________?
Show answer Hide answer
Answer: D. first increase, reach maximum and then decrease
As the pressure ratio increases in a gas turbine the specific work output initially rises and peaks. Further increases in pressure ratio cause compressor work requirements to grow faster than turbine power gains. This th...
Q6. Gas turbine work ratios can be enhanced through____________________?
Show answer Hide answer
Answer: E. A. and C. above
The work ratio of a gas turbine measures net work output divided by the total positive work produced by the turbine. Decreasing the work required for compression leaves more net power available for external mechanical wo...