Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 56990

The circulating working medium utilized within closed air turbines is___________________?

Select your answer for: The circulating working medium utilized within closed air turbines is___________________?
Show answer

Answer: C. in a single phase

Explanation

Closed-cycle air turbines rely on a working fluid that stays in a gaseous phase throughout operation. Air does not undergo phase change inside the closed loop of this specific thermodynamic power cycle. Maintaining a single phase prevents the complex heat transfer and erosion issues associated with two-phase fluids. Closed-cycle turbines circulate a working gas through a continuous loop containing a compressor, heater, and turbine. Unlike steam power plants, air turbines do not boil water into vapor inside the primary power circuit. Single-phase working fluids simplify thermodynamic cycle analysis and reduce mechanical wear on internal turbine blades.

Two-phase systems involve boiling and condensation processes typical of standard steam Rankine power cycles. Three-phase states apply to thermodynamic triple points rather than standard operational gas turbine working fluids. Describing the medium as an air and water mixture confuses closed-air cycles with wet steam power plants.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Branch piping connections off main compressed air headers should originate where to prevent moisture contamination_________________?

Select your answer for: Branch piping connections off main compressed air headers should originate where to prevent moisture contamination_________________?
Show answer

Answer: A. top side of main

Branch lines should always connect to the top side of main compressed air headers to prevent accumulated condensation and moisture at the bottom from flowing into the branch. Condensate naturally separates from compresse...

Q2. Axial thrust forces acting on a centrifugal compressor rotor originate from________________?

Select your answer for: Axial thrust forces acting on a centrifugal compressor rotor originate from________________?
Show answer

Answer: B. axial component

Axial thrust in a centrifugal compressor is generated by pressure differentials across axial projected areas. The axial component of aerodynamic forces pushes against the impeller shroud and hub surfaces. Unbalanced pres...

Q3. What is the volumetric efficiency of a clearance-free compressor________________?

Select your answer for: What is the volumetric efficiency of a clearance-free compressor________________?
Show answer

Answer: C. is not dependent upon compressin ratio

In a theoretical clearance-free compressor all trapped air is expelled during the discharge stroke completely. This complete expulsion eliminates the re-expansion of residual clearance gases during the subsequent intake...

Q4. Water injection is integrated into gas turbine cycles in order to___________________?

Select your answer for: Water injection is integrated into gas turbine cycles in order to___________________?
Show answer

Answer: B. control output of turbine

Water injection into gas turbines is utilized to increase mass flow and control or boost the power output of the turbine. Injecting liquid water into the combustion chamber or compressor discharge causes it to flash into...

Q5. Identify the false claim regarding the advantages of multi-stage versus single-stage compression_________________?

Select your answer for: Identify the false claim regarding the advantages of multi-stage versus single-stage compression_________________?
Show answer

Answer: E. lower volumetric efficiency

Multi-stage compression actually improves volumetric efficiency compared to single-stage compression by reducing the pressure range per cylinder and minimizing clearance expansion losses.

Q6. Engine connecting rods are predominantly fabricated from_________________?

Select your answer for: Engine connecting rods are predominantly fabricated from_________________?
Show answer

Answer: C. medium carbon steel

Engine connecting rods require high tensile strength and toughness, typically achieved using medium carbon steels. Medium carbon steels provide an optimal balance of ductility, hardness, and fatigue resistance under load...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test