The resulting mechanical effect of a force on a body is governed by________________?
Show answer Hide answer
Answer: D. all of the above
Explanation
The resulting mechanical effect of a force on a rigid body depends on its magnitude, direction, and line of action. Changing any of these three fundamental characteristics alters the net translational or rotational response. Mechanics of rigid bodies relies on the principle of transmissibility involving the line of action. Force is a vector quantity fully defined by its point of application, magnitude, and direction line. The moment produced by a force depends directly on its magnitude and perpendicular distance line. Rigid body statics analyzes how forces induce both linear acceleration and rotational moments.
Structural engineers must account for force magnitudes and lines of action to prevent structural failure. Mechanical design requires precise placement of applied forces to control internal stress distributions. Understanding force mechanics is fundamental to analyzing complex machinery and truss structures. Option A considers only magnitude, ignoring directional and positional mechanical effects. Option B considers only direction, neglecting force magnitude and line of action parameters. Option C considers only position, omitting essential magnitude and directional vector properties.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Applying a force to a physical body can induce_________________?
Show answer Hide answer
Answer: E. all of the above
Applying an external force to a physical body can induce internal mechanical stresses throughout its material structure. Forces can act to balance other applied loads, thereby maintaining the body in a state of static eq...
Q2. The center of gravity for a solid conical mass is located along its axis at a height of_____________________?
Show answer Hide answer
Answer: A. one-fourth of the total height above base
The center of gravity of a solid right circular cone sits at one fourth of its total height. This vertical position is measured upward directly from the flat circular base of the cone. Integration of mass distribution ac...
Q3. The principle of transmissibility states that the mechanical action of a force on a rigid body_________________?
Show answer Hide answer
Answer: C. the same at every point in its line of action
The principle of transmissibility applies strictly to rigid body mechanical analysis. Sliding a force vector along its exact line of action leaves external effects unchanged. Internal stresses may alter, but external rig...
Q4. Coulomb friction describes the resistive force occurring between _________________?
Show answer Hide answer
Answer: A. bodies having relative motion
Coulomb friction describes the resistive force encountered when two solid bodies experience relative sliding motion. This classical friction model assumes frictional resistance is proportional to normal force and indepen...
Q5. For dry sliding surfaces, frictional resistance is________________?
Show answer Hide answer
Answer: C. proportional to velocity of sliding
Kinetic frictional resistance for dry sliding surfaces remains proportional to velocity over standard ranges. Frictional force behavior changes with sliding speed depending on lubrication and surface roughness properties...
Q6. An overhead trolley wire has a mass of 1.2 kg per meter. Its ends are secured to poles spaced 20 meters apart. Given a horizontal tension load of 1500 kg, calculate the center sag (dip) of the span___________________?
Show answer Hide answer
Answer: C. 4.0 cm
Cable sag formulas calculate center dip using distributed weight and span tension. Multiplying mass per meter by span squared and dividing by eight times tension gives sag. Substituting one point two kg per meter and fif...