Applying a force to a physical body can induce_________________?
Show answer Hide answer
Answer: E. all of the above
Explanation
Applying an external force to a physical body can induce internal mechanical stresses throughout its material structure. Forces can act to balance other applied loads, thereby maintaining the body in a state of static equilibrium. Forces can also accelerate, decelerate, or redirect the motion of a body in accordance with Newtonian dynamics. Newtonian mechanics state that a net force acting on a body causes an acceleration proportional to its mass. Internal stresses represent distributed resistive forces that particles exert on adjacent particles within deformed bodies. Dynamic equilibrium principles allow engineers to analyze moving bodies by treating inertial forces as applied loads.
Introducing internal stresses is true but represents only one of several possible mechanical effects of applied forces. Retarding motion is also correct but covers just deceleration rather than acceleration or internal stress generation. Option E correctly encompasses all valid mechanical responses that a body can experience under applied forces.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. The triangle of forces theorem states that __________________ ?
Show answer Hide answer
Answer: C. if three forces acting upon a patticle are represented in magnitude and direction by the sides of a triangle, taken in order, they will be in equilibrium
The triangle of forces theorem applies to three concurrent forces in static equilibrium. Representing these forces as sides of a triangle in correct order proves balance. Vector addition of these three forces forms a clo...
Q2. A mechanical force is fully characterized when one defines_______________?
Show answer Hide answer
Answer: D. all of the above
A mechanical force is fully defined as a vector by specifying its magnitude, direction, and point of application. Knowing only the push or pull strength is insufficient without knowing the directional line of action. The...
Q3. A metallic specimen registers 219 gms in air, 180 gms in water, and 120 gms in an alternate fluid. Which assertion regarding the metal's density is correct_________________?
Show answer Hide answer
Answer: A. density of metal can’t be determined
Without knowing the exact volume or mass of the metallic specimen independently, absolute density is uncalculatable. Buoyancy measurements in multiple fluids provide relative ratios but lack a direct volume reference. Mi...
Q4. The principle of transmissibility states that the mechanical action of a force on a rigid body_________________?
Show answer Hide answer
Answer: C. the same at every point in its line of action
The principle of transmissibility applies strictly to rigid body mechanical analysis. Sliding a force vector along its exact line of action leaves external effects unchanged. Internal stresses may alter, but external rig...
Q5. The center of gravity for a thin hollow conical shell lies along its axis at what fractional height___________________?
Show answer Hide answer
Answer: B. one-third of the total height above base
The center of gravity for a thin hollow conical shell lies along its axis at one-third of the total height above the base. Integrating the elemental surface areas of a hollow cone yields a centroid located closer to the...
Q6. The resulting mechanical effect of a force on a body is governed by________________?
Show answer Hide answer
Answer: D. all of the above
The resulting mechanical effect of a force on a rigid body depends on its magnitude, direction, and line of action. Changing any of these three fundamental characteristics alters the net translational or rotational respo...