A semicircular disc rests on a horizontal plane with its flat edge horizontal and curved base downward. The static friction coefficient between the disc and plane is \i. Pulling the disc via a horizontal edge force while maintaining a horizontal orientation causes the top force to behave in what manner when movement impends____________________?
Show answer Hide answer
Answer: C. slant down towards direction of pull
Explanation
When pulling a semicircular disc horizontally from its top edge as motion impends the line of action slants downward. Friction forces at the base combined with the applied pull shift the resultant reaction vector angle. Equilibrium requirements dictate that this reaction force must tilt downward toward the direction of the applied pull. A semicircular disc resting on a flat horizontal plane possesses a curved base and a flat upper edge. Static friction creates a resisting force parallel to the contact surface opposing the impending horizontal movement. The line of action of a force represents the infinite straight line along which the force vector acts.
Option A is incorrect because the resultant reaction vector changes inclination when motion impends. Option B is wrong as equilibrium force balancing forces the reaction line to slant downward instead of upward. Option D and E are incorrect because the physical behavior of the disc is completely governed by statics laws.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. A concurrent system of forces acting at a point achieves static equilibrium when_____________________?
Show answer Hide answer
Answer: C. sum of resolved parts in any two per-pendicular directions are both zero
Concurrent force systems achieve static equilibrium when force components in perpendicular directions sum to zero. The algebraic sum of resolved force parts in any two orthogonal directions must equal zero. Balancing all...
Q2. The triangle of forces theorem states that __________________ ?
Show answer Hide answer
Answer: C. if three forces acting upon a patticle are represented in magnitude and direction by the sides of a triangle, taken in order, they will be in equilibrium
The triangle of forces theorem applies to three concurrent forces in static equilibrium. Representing these forces as sides of a triangle in correct order proves balance. Vector addition of these three forces forms a clo...
Q3. A mechanical force is fully characterized when one defines_______________?
Show answer Hide answer
Answer: D. all of the above
A mechanical force is fully defined as a vector by specifying its magnitude, direction, and point of application. Knowing only the push or pull strength is insufficient without knowing the directional line of action. The...
Q4. The center of gravity for a solid conical mass is located along its axis at a height of_____________________?
Show answer Hide answer
Answer: A. one-fourth of the total height above base
The center of gravity of a solid right circular cone sits at one fourth of its total height. This vertical position is measured upward directly from the flat circular base of the cone. Integration of mass distribution ac...
Q5. The principle of transmissibility states that the mechanical action of a force on a rigid body_________________?
Show answer Hide answer
Answer: C. the same at every point in its line of action
The principle of transmissibility applies strictly to rigid body mechanical analysis. Sliding a force vector along its exact line of action leaves external effects unchanged. Internal stresses may alter, but external rig...
Q6. The center of gravity for a thin hollow conical shell lies along its axis at what fractional height___________________?
Show answer Hide answer
Answer: B. one-third of the total height above base
The center of gravity for a thin hollow conical shell lies along its axis at one-third of the total height above the base. Integrating the elemental surface areas of a hollow cone yields a centroid located closer to the...