A thermocouple's time constant is defined as_______________?
Show answer Hide answer
Answer: C. the time taken to attain 63.2% of the value of initial temperature difference
Explanation
The time constant of a thermocouple defines the duration required to reach 63.2 percent of an initial temperature step change. This mathematical percentage corresponds to one minus the reciprocal of Euler's constant in exponential decay formulas. Sensor response testing relies on this standard metric to evaluate how quickly a thermometer tracks thermal transients. First-order thermal systems exhibit exponential temperature response curves when subjected to sudden environmental shifts. The mathematical expression for transient sensor heating involves time constants in the exponent denominator. Faster thermocouple response times require smaller junction beads and higher thermal diffusivity sheath materials.
Industrial process control systems require sensors with known time constants to prevent lag-induced regulation errors. Aerodynamic testing wind tunnels utilize ultra-fast thermocouples to capture rapid temperature fluctuations. Selecting appropriate temperature sensors depends on matching the time constant to the expected process dynamics. Reaching one hundred percent of the final temperature takes infinitely long due to asymptotic exponential curves. Reaching fifty percent represents the half-life time rather than the standard thermal time constant definition. Calibration points like zero and one hundred degrees Celsius describe fixed temperature scales rather than time constants.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. The constant ratio of emissive power to absorptive power for all bodies, equaling a black body's emissive power, is known as_________________?
Show answer Hide answer
Answer: A. Krichoff’s law
Kirchhoff law states that emissivity equals absorptivity for any body in thermal equilibrium. The ratio of emissive power to absorptive power remains constant for all surfaces. This universal constant equals the emissive...
Q2. Counter-flow heat exchangers are characterized by_________________?
Show answer Hide answer
Answer: B. both the fluids at inlet are in their hot¬test state
In counter-flow heat exchangers, the two fluid streams travel in opposite directions through the assembly. Consequently, the hot fluid enters at its maximum temperature while the cold fluid enters at its lowest. This opp...
Q3. Regenerator-type heat exchangers transfer heat through___________________?
Show answer Hide answer
Answer: C. flow of hot and cold fluids alternately over a surface
Regenerative heat exchangers operate by passing hot and cold fluids alternately over a solid thermal storage matrix. Hot fluid first flows through the matrix to deposit thermal energy into the solid storage material. Col...
Q4. Steam temperatures near 540°C are typically measured using ____________________?
Show answer Hide answer
Answer: D. thermocouple
Thermocouples are widely used for industrial temperature measurements around 540 degrees Celsius reliably. Specific alloy combinations allow thermocouples to withstand high steam environments without degrading rapidly. T...
Q5. Moisture contamination will cause an insulator's thermal resistance to_________________?
Show answer Hide answer
Answer: B. decrease
Moisture fills the microscopic air pockets inside thermal insulation materials with liquid water. Liquid water possesses a much higher thermal conductivity than trapped static atmospheric air. Higher thermal conductivity...
Q6. The heat flux ratio Q1/Q2 through two equal-thickness walls with thermal conductivities ATj and 2K2 will be________________?
Show answer Hide answer
Answer: C. 2
Heat flux through a flat wall is directly proportional to its thermal conductivity under equal temperature drops. Given equal wall thicknesses and temperature differences, the heat flux ratio equals the thermal conductiv...