Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57230

The heat flux ratio Q1/Q2 through two equal-thickness walls with thermal conductivities ATj and 2K2 will be________________?

Select your answer for: The heat flux ratio Q1/Q2 through two equal-thickness walls with thermal conductivities ATj and 2K2 will be________________?
Show answer

Answer: C. 2

Explanation

Heat flux through a flat wall is directly proportional to its thermal conductivity under equal temperature drops. Given equal wall thicknesses and temperature differences, the heat flux ratio equals the thermal conductivity ratio. Dividing the first conductivity value by the second yields a direct mathematical ratio of two. Fourier's law of conduction states that heat flux equals conductivity multiplied by the temperature gradient. Steady-state heat transfer through plane walls assumes uniform material composition and constant thermal properties. Dimensional consistency ensures that direct property ratios yield dimensionless numbers for comparative heat flux.

Insulation panels with varying material properties are evaluated using simple heat flux ratio calculations. Industrial furnace linings combine different refractory bricks requiring careful heat flux continuity analysis. Electronic cooling plates balance material thermal conductivities to optimize localized heat dissipation rates. A ratio of one would only occur if both walls possessed identical thermal conductivities and boundary conditions. A value of 0.5 represents the inverse ratio which would incorrectly prioritize the lower conductivity wall. Values like 0.25 or 4.0 arise from squared property dependencies not applicable to simple linear conduction.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. A thermocouple's time constant is defined as_______________?

Select your answer for: A thermocouple's time constant is defined as_______________?
Show answer

Answer: C. the time taken to attain 63.2% of the value of initial temperature difference

The time constant of a thermocouple defines the duration required to reach 63.2 percent of an initial temperature step change. This mathematical percentage corresponds to one minus the reciprocal of Euler's constant in e...

Q2. Stefan’s law states that total black body radiation per unit area per second is proportional to____________________?

Select your answer for: Stefan’s law states that total black body radiation per unit area per second is proportional to____________________?
Show answer

Answer: D. t

Stefan's law states that total black body radiation energy is proportional to the fourth power of absolute temperature.

Q3. Steam temperatures near 540°C are typically measured using ____________________?

Select your answer for: Steam temperatures near 540°C are typically measured using ____________________?
Show answer

Answer: D. thermocouple

Thermocouples are widely used for industrial temperature measurements around 540 degrees Celsius reliably. Specific alloy combinations allow thermocouples to withstand high steam environments without degrading rapidly. T...

Q4. The overall heat transfer coefficient is expressed in units of___________________?

Select your answer for: The overall heat transfer coefficient is expressed in units of___________________?
Show answer

Answer: C. kcal/m2 hr °C

The overall heat transfer coefficient accounts for thermal resistance across multiple material and fluid layers. Heat flux equals the coefficient multiplied by area and temperature difference across the system. Option C...

Q5. The degree of approach in a heat exchanger refers to the temperature difference between________________?

Select your answer for: The degree of approach in a heat exchanger refers to the temperature difference between________________?
Show answer

Answer: D. hot medium outlet and cold water outlet

The degree of approach in a heat exchanger measures the temperature difference between the hot fluid outlet and cold fluid outlet. It serves as a key performance indicator reflecting how closely the exiting fluid tempera...

Q6. Gases generally exhibit thermal diffusivities that are_____________________?

Select your answer for: Gases generally exhibit thermal diffusivities that are_____________________?
Show answer

Answer: A. more than those for liquids

Gases generally have higher thermal diffusivities than liquids due to their large kinematic viscosities. Molecular spacing in gases allows momentum to diffuse much faster relative to thermal energy storage. While liquid...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test