Total emissive power is defined as the aggregate radiation emitted by a black body per unit_______________?
Show answer Hide answer
Answer: D. time
Explanation
Emissive power quantifies emitted thermal radiation relative to both physical surface area and operating time. Dividing total radiated energy by area and time yields the standard heat flux expression. Option D correctly isolates time as a required denominator alongside area for power definitions. Total emissive power integrates radiation intensity across all possible hemispherical emission angles. The Stefan-Boltzmann law calculates total emissive power using surface temperature raised to the fourth power. Units of emissive power are typically expressed in watts per square meter of radiating surface.
Thermal imaging cameras measure emissive power to determine surface temperatures of industrial machinery. Solar power collectors are evaluated based on their ability to capture and retain emitted radiation. Astrophysicists use emissive power principles to calculate energy output of distant stars and planets. Option A is incorrect because temperature drives emission rather than serving as a unit denominator. Option B thickness is irrelevant for surface radiation emission calculations involving opaque boundaries. Options C and E are incomplete or incorrect since time is an essential component of power.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Radiant heat exchange is primarily governed by___________________?
Show answer Hide answer
Answer: D. all of the above
Radiant heat exchange is governed by the absolute temperatures of the interacting physical bodies. The surface type and material emittance strongly influence how much thermal radiation is emitted. Geometric view factors...
Q2. The constant ratio of emissive power to absorptive power for all bodies, equaling a black body's emissive power, is known as_________________?
Show answer Hide answer
Answer: A. Krichoff’s law
Kirchhoff law states that emissivity equals absorptivity for any body in thermal equilibrium. The ratio of emissive power to absorptive power remains constant for all surfaces. This universal constant equals the emissive...
Q3. Counter-flow heat exchangers are characterized by_________________?
Show answer Hide answer
Answer: B. both the fluids at inlet are in their hot¬test state
In counter-flow heat exchangers, the two fluid streams travel in opposite directions through the assembly. Consequently, the hot fluid enters at its maximum temperature while the cold fluid enters at its lowest. This opp...
Q4. Stefan’s law states that total black body radiation per unit area per second is proportional to____________________?
Show answer Hide answer
Answer: D. t
Stefan's law states that total black body radiation energy is proportional to the fourth power of absolute temperature.
Q5. Steam temperatures near 540°C are typically measured using ____________________?
Show answer Hide answer
Answer: D. thermocouple
Thermocouples are widely used for industrial temperature measurements around 540 degrees Celsius reliably. Specific alloy combinations allow thermocouples to withstand high steam environments without degrading rapidly. T...
Q6. Moisture contamination will cause an insulator's thermal resistance to_________________?
Show answer Hide answer
Answer: B. decrease
Moisture fills the microscopic air pockets inside thermal insulation materials with liquid water. Liquid water possesses a much higher thermal conductivity than trapped static atmospheric air. Higher thermal conductivity...