Regenerator-type heat exchangers transfer heat through___________________?
Show answer Hide answer
Answer: C. flow of hot and cold fluids alternately over a surface
Explanation
Regenerative heat exchangers operate by passing hot and cold fluids alternately over a solid thermal storage matrix. Hot fluid first flows through the matrix to deposit thermal energy into the solid storage material. Cold fluid then flows over the same heated matrix to absorb the stored thermal energy efficiently. Heat exchangers are engineered devices designed to transfer thermal energy between two or more fluids. Regenerators differ from recuperators because fluids share the same flow passages at different times. Thermal matrix materials often consist of ceramic or metallic mesh structures with high heat capacity.
Gas turbine power plants use regenerators to preheat incoming combustion air using hot exhaust gases. Industrial rotary regenerators improve overall thermal efficiency in steel manufacturing blast furnaces. Stirling engines rely on internal regenerators to shuttle working gas between hot and cold heat exchangers. Direct mixing of hot and cold fluids describes open feedwater heaters rather than solid-matrix regenerators. Complete physical separation with simultaneous fluid flow describes recuperative shell-and-tube heat exchangers. Generation of heat again and again violates the fundamental law of energy conservation.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Metals function as good thermal conductors because________________?
Show answer Hide answer
Answer: A. their atoms collide frequently
Metals are good thermal conductors because they contain a high concentration of free electrons that rapidly transport thermal energy.
Q2. Radiant heat exchange is primarily governed by___________________?
Show answer Hide answer
Answer: D. all of the above
Radiant heat exchange is governed by the absolute temperatures of the interacting physical bodies. The surface type and material emittance strongly influence how much thermal radiation is emitted. Geometric view factors...
Q3. The constant ratio of emissive power to absorptive power for all bodies, equaling a black body's emissive power, is known as_________________?
Show answer Hide answer
Answer: A. Krichoff’s law
Kirchhoff law states that emissivity equals absorptivity for any body in thermal equilibrium. The ratio of emissive power to absorptive power remains constant for all surfaces. This universal constant equals the emissive...
Q4. A thermocouple's time constant is defined as_______________?
Show answer Hide answer
Answer: C. the time taken to attain 63.2% of the value of initial temperature difference
The time constant of a thermocouple defines the duration required to reach 63.2 percent of an initial temperature step change. This mathematical percentage corresponds to one minus the reciprocal of Euler's constant in e...
Q5. Stefan’s law states that total black body radiation per unit area per second is proportional to____________________?
Show answer Hide answer
Answer: D. t
Stefan's law states that total black body radiation energy is proportional to the fourth power of absolute temperature.
Q6. Steam temperatures near 540°C are typically measured using ____________________?
Show answer Hide answer
Answer: D. thermocouple
Thermocouples are widely used for industrial temperature measurements around 540 degrees Celsius reliably. Specific alloy combinations allow thermocouples to withstand high steam environments without degrading rapidly. T...