Why is an excessive sulphur content in diesel fuel considered undesirable______________?
Show answer Hide answer
Answer: D. detonation
Explanation
Excessive sulphur content in diesel fuel forms corrosive sulfurous and sulfuric acids during combustion. These corrosive acids attack metal surfaces inside the combustion chamber, causing severe ring and cylinder wear. High sulphur fuels require specialized alkaline engine lubricating oils to neutralize acid condensation damage. Sulphur present in crude oil carries over into diesel fuel unless removed via advanced hydrotreating refining. Acid condensation occurs when cylinder wall temperatures drop below the local acid dew point temperature. Environmental regulations restrict maximum allowable sulphur limits in commercial automotive diesel fuels.
Marine diesel engines burning heavy residual fuel oils experience accelerated corrosive cylinder liner wear. Modern low-sulphur diesel fuel standards protect both exhaust emission catalysts and internal engine components. Lubricating oil additive packages are formulated specifically to neutralize corrosive combustion acid byproducts. Piston ring and cylinder wear results directly from acid corrosion rather than being an unrelated phenomenon. Hard carbon deposits on piston skirts stem from incomplete combustion rather than fuel sulphur content. Crankcase oil sludge forms from oxidized oil and soot contamination rather than direct sulphur reactions.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Fuel oil flash point refers to__________________?
Show answer Hide answer
Answer: A. minimum temperature to which1 oil is heated in order to give off inflammable vapours in sufficient quantity to ignite momentarily when brought in contact with a flame
Flash point is the lowest temperature where fuel oil releases enough vapor to ignite near a flame. It indicates the volatility and fire safety hazard level of liquid hydrocarbon fuels. Option A correctly defines the mini...
Q2. Diesel engines can operate on lean mixtures up to 30:1; petrol engines can achieve similar lean operation provided__________________?
Show answer Hide answer
Answer: C. can not work as it is impossible
Conventional spark-ignition petrol engines cannot operate on extremely lean mixtures like 30 to 1. Combustion stability breaks down entirely when the air-fuel ratio becomes too lean in petrol engines. Severe engine misfi...
Q3. Fuel consumption guarantees for I.C. engines generally rely upon__________________?
Show answer Hide answer
Answer: B. high heat value of oil
Fuel consumption guarantees for internal combustion engines are traditionally based on high heat value. Gross calorific value provides a conservative and standardized baseline for commercial engine warranties. Standardiz...
Q4. Why is diesel engine fuel consumption not guaranteed at one-quarter load________________?
Show answer Hide answer
Answer: C. the small difference in cooling water temperature or in internal friction has a disproportionate effect
At low quarter loads, friction and heat losses consume a large fraction of total engine power. Small variations in internal friction or cooling water temperature drastically skew fuel consumption data. Option C correctly...
Q5. For generating equal power in internal combustion engines, the more economical system is_____________?
Show answer Hide answer
Answer: B. supercharged
Supercharged engines provide a higher air mass per cycle to generate greater power efficiently. Forcing additional air into the cylinders allows more fuel to be burned completely during each power stroke. This increased...
Q6. Raising an Otto cycle engine's compression ratio from 5 to 7 increases thermal efficiency by a percentage of________________?
Show answer Hide answer
Answer: D. 14%
Increasing the compression ratio from 5 to 7 yields approximately a 14 percent efficiency increase. Otto cycle thermal efficiency is governed mathematically by the compression ratio and specific heat ratio. Air-standard...