Why is diesel engine fuel consumption not guaranteed at one-quarter load________________?
Show answer Hide answer
Answer: C. the small difference in cooling water temperature or in internal friction has a disproportionate effect
Explanation
At low quarter loads, friction and heat losses consume a large fraction of total engine power. Small variations in internal friction or cooling water temperature drastically skew fuel consumption data. Option C correctly explains why guarantees are avoided due to disproportionate parasitic losses. Mechanical efficiency drops sharply at low engine loads because friction losses remain nearly constant. Thermal losses to cooling jackets represent a higher percentage of total energy at low power output. Engine manufacturers typically guarantee fuel consumption only at optimal design load ranges.
Diesel generators operating in variable load facilities experience reduced efficiency at idle or low load. Engine test bed procedures account for frictional uncertainties when measuring part-load performance. Selecting appropriately sized engines prevents prolonged operation in inefficient low load conditions. Option A friction is high, but variability and disproportionate effects cause the guarantee omission. Option B friction is not unpredictable, but its relative impact at low loads is disproportionate. Options D and E fail to identify the core thermodynamic reasons for withholding guarantees.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Fuel consumption guarantees for I.C. engines generally rely upon__________________?
Show answer Hide answer
Answer: B. high heat value of oil
Fuel consumption guarantees for internal combustion engines are traditionally based on high heat value. Gross calorific value provides a conservative and standardized baseline for commercial engine warranties. Standardiz...
Q2. Gaseous fuel guarantees are established based on___________________?
Show answer Hide answer
Answer: B. low heat value of oil
Gaseous fuel guarantees are conventionally established using the low heat value of the gas to ensure consistent performance standards. The low heat value excludes the latent heat of vaporization of water vapor formed dur...
Q3. Why is an excessive sulphur content in diesel fuel considered undesirable______________?
Show answer Hide answer
Answer: D. detonation
Excessive sulphur content in diesel fuel forms corrosive sulfurous and sulfuric acids during combustion. These corrosive acids attack metal surfaces inside the combustion chamber, causing severe ring and cylinder wear. H...
Q4. Raising an Otto cycle engine's compression ratio from 5 to 7 increases thermal efficiency by a percentage of________________?
Show answer Hide answer
Answer: D. 14%
Increasing the compression ratio from 5 to 7 yields approximately a 14 percent efficiency increase. Otto cycle thermal efficiency is governed mathematically by the compression ratio and specific heat ratio. Air-standard...
Q5. An increase in intake air temperature causes internal combustion engine efficiency to_________________?
Show answer Hide answer
Answer: B. decrease
Higher intake air temperatures reduce air density, directly lowering the volumetric efficiency of the internal combustion engine. Reduced air density means fewer oxygen molecules enter the cylinder, decreasing the total...
Q6. Multistage centrifugal pumps are deployed to deliver___________________?
Show answer Hide answer
Answer: B. high head
Multistage centrifugal pumps use multiple impellers arranged in series on a common shaft to deliver high head. Each individual impeller adds a fraction of the total required pressure head incrementally to the fluid. This...