While highly efficient, isothermal compression is impractical because_________________?
Show answer Hide answer
Answer: D. compressor has to run at very slow speed to achieve it
Explanation
Isothermal compression requires gas temperature to remain constant by continuously removing heat during the process. Rapid compression generates heat quickly, meaning effective heat rejection requires massive surface areas and slow operation. Compressors must therefore operate at extremely slow speeds to allow enough time for complete thermal energy transfer. Isothermal processes follow Boyle's law where pressure and volume changes occur at a perfectly constant absolute temperature. Actual industrial compressors operate closer to adiabatic conditions because compression cycles happen too fast for cooling. Thermodynamic efficiency theoretically peaks during isothermal compression, saving significant mechanical drive power.
Industrial compressed air facilities utilize multi-stage intercooling to approximate isothermal compression without extreme delays. Pneumatic systems benefit from efficient compression cycles to reduce overall electrical energy consumption costs. Engineers weigh the mechanical impracticality of slow speeds against the thermodynamic benefits of constant temperature compression. Large cylinders are used for displacement capacity rather than being the primary limitation preventing isothermal compression. Isothermal processes can achieve significant pressure increases provided sufficient heat rejection time is available. Stating that isothermal compression is universally impossible ignores the fact that it is merely impractical due to speed.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Which boiler is recommended for generating large steam volumes at low pressure?
Show answer Hide answer
Answer: C. lancashire boiler
Lancashire boilers generate large steam volumes at relatively low pressures. Their large shell capacity holds significant water volume for steady operations. Internal fire tubes provide adequate heating surface for indus...
Q2. Kerosene distillation occurs at________________?
Show answer Hide answer
Answer: C. 220 – 350°C
Kerosene is a petroleum distillate fraction that vaporizes within a specific boiling range. This fractional distillation process occurs between the temperature limits of 220°C and 350°C. Heated crude oil components separ...
Q3. Isothermal compression efficiency, even at high speeds, is approached through A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Show answer Hide answer
Answer: C. both A. and B. above
Multi-stage compression with intercooling removes heat between stages to keep temperatures low. Cold water sprays injected into the cylinder absorb heat directly during the compression process. Both methods limit tempera...
Q4. Inconel is categorized as an alloy of___________________?
Show answer Hide answer
Answer: A. nickel, chromium and iron
Inconel is categorized as an alloy of nickel, chromium, and iron. Metallurgical compositions of superalloys include high percentages of nickel. Adding chromium and iron provides exceptional resistance to oxidation and co...
Q5. Achieving isothermal compression efficiency requires operating the compressor__________________?
Show answer Hide answer
Answer: B. at very slow speed
To allow enough time for heat rejection and approximate an isothermal process, a compressor must run slowly. Running a compressor at very slow speeds keeps gas temperatures from rising during the compression cycle. Therm...
Q6. Large forgings, crankshafts, and axles typically contain carbon up to________________?
Show answer Hide answer
Answer: C. 0.45 to 0.55%
Medium carbon steels used for heavy forgings contain carbon ranging from 0.45 to 0.55 percent. This specific carbon concentration provides a favorable balance of high tensile strength and toughness. Heat treatment proces...