Kinematic viscosity is formulated as_________________?
Show answer Hide answer
Answer: A. dynamic viscosity/density
Explanation
Kinematic viscosity relates dynamic fluid friction directly to the inertial mass density of the fluid. Mathematical formulation defines kinematic viscosity as dynamic viscosity divided by fluid density. This ratio simplifies Navier-Stokes equations for fluid flow where gravitational and inertial forces dominate. Dynamic viscosity measures a fluid resistance to shear deformation under applied mechanical forces. Density represents mass per unit volume of the fluid substance at specified temperatures. Standard units for kinematic viscosity include square meters per second or standard Stokes.
Hydraulic engineers use kinematic viscosity values to calculate Reynolds numbers and determine flow regimes. Lubrication science requires kinematic viscosity data to predict oil film thickness in rotating journal bearings. Meteorological models incorporate kinematic viscosity when simulating atmospheric boundary layer wind profiles. Multiplying dynamic viscosity by density yields incorrect dimensional units inconsistent with kinematic viscosity. Inverting the ratio produces inverse kinematic units that violate classical fluid mechanics definitions. Treating kinematic and dynamic viscosity as identical ignores the crucial role of fluid density.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Kerosene distillation occurs at________________?
Show answer Hide answer
Answer: C. 220 – 350°C
Kerosene is a petroleum distillate fraction that vaporizes within a specific boiling range. This fractional distillation process occurs between the temperature limits of 220°C and 350°C. Heated crude oil components separ...
Q2. Isothermal compression efficiency, even at high speeds, is approached through A. multi-stage compression B. cold water spray C. both A. and B. above D. fully insulating the cylinder E. high stroke_________________?
Show answer Hide answer
Answer: C. both A. and B. above
Multi-stage compression with intercooling removes heat between stages to keep temperatures low. Cold water sprays injected into the cylinder absorb heat directly during the compression process. Both methods limit tempera...
Q3. Killed steels are defined as those steels that have been__________________?
Show answer Hide answer
Answer: C. which are deoxidised in the ladle with silicon and aluminium
Killed steels are fully deoxidized in the steelmaking ladle using active deoxidizing elements like silicon and aluminum. This chemical deoxidation eliminates dissolved oxygen before casting, preventing carbon monoxide ga...
Q4. Achieving isothermal compression efficiency requires operating the compressor__________________?
Show answer Hide answer
Answer: B. at very slow speed
To allow enough time for heat rejection and approximate an isothermal process, a compressor must run slowly. Running a compressor at very slow speeds keeps gas temperatures from rising during the compression cycle. Therm...
Q5. Large forgings, crankshafts, and axles typically contain carbon up to________________?
Show answer Hide answer
Answer: C. 0.45 to 0.55%
Medium carbon steels used for heavy forgings contain carbon ranging from 0.45 to 0.55 percent. This specific carbon concentration provides a favorable balance of high tensile strength and toughness. Heat treatment proces...
Q6. Pouring lead into pipe joints is suitable for pipes fabricated from____________________?
Show answer Hide answer
Answer: A. cast iron
Pouring molten lead into pipe joints is a traditional method suitable for pipes fabricated from cast iron. Cast iron bell-and-spigot joints provide the necessary thermal mass and rigidity to contain molten lead safely. O...