Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57335

Reaction turbine discharge varies with increased unit speed by____________________?

Select your answer for: Reaction turbine discharge varies with increased unit speed by____________________?
Show answer

Answer: B. decreases

Explanation

In reaction turbines, fluid discharge decreases as the unit rotational speed increases under constant head. Centrifugal forces generated by the rotating runner create an opposing pressure head that restricts incoming flow. This self-regulating hydraulic characteristic links rotational speed directly to volumetric discharge capacity. Turbine characteristic curves plot discharge, power, and efficiency against unit speed and head parameters. Euler's turbine equation accounts for tangential velocity components affected by runner rotational speed changes. Hydraulic throttling occurs when excessive runner speeds impede smooth water passage through runner channels.

Hydroelectric turbine governors monitor rotational speed to maintain stable frequency output under varying loads. Sudden electrical load rejections cause turbine speed to spike, momentarily reducing water flow discharge. Dam operators analyze discharge curves to prevent unstable hydraulic operating zones during load swings. Discharge increasing with speed would create unstable runaway conditions dangerous to turbine mechanical integrity. Remaining unaffected contradicts fundamental turbomachinery fluid dynamics and centrifugal pressure head effects. Complex non-monotonic variations like first increasing then decreasing do not reflect standard reaction turbine behavior.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. For a piping system primarily consisting of vertical lift with minimal friction, pump characteristics should be_________________?

Select your answer for: For a piping system primarily consisting of vertical lift with minimal friction, pump characteristics should be_________________?
Show answer

Answer: C. steep

When static lift dominates piping head, pump performance curves must be steep to maintain flow. A steep head-capacity curve prevents large flow rate swings when minor head variations occur. Option C correctly identifies...

Q2. Which section of a hydraulic turbine is most vulnerable to cavitation damage__________________?

Select your answer for: Which section of a hydraulic turbine is most vulnerable to cavitation damage__________________?
Show answer

Answer: A. inlet of draft rube

The inlet of the draft tube experiences the lowest absolute static pressure within any reaction hydraulic turbine. When local pressure drops below the vapor pressure of water, vapor bubbles form and collapse violently. T...

Q3. Hydrometers are utilized to measure____________________?

Select your answer for: Hydrometers are utilized to measure____________________?
Show answer

Answer: A. specific gravity of liquids

Hydrometers are floating glass instruments used to measure the specific gravity of liquids. Archimedes principle dictates that a weighted bulb floats at depths proportional to liquid density. Graduated stems on hydromete...

Q4. Peak flame speed inside a diesel engine occurs at this air-fuel ratio_______________?

Select your answer for: Peak flame speed inside a diesel engine occurs at this air-fuel ratio_______________?
Show answer

Answer: D. about 10% rich mixture

Peak flame speed and optimal combustion velocity in engines occur with slightly rich fuel mixtures. A fuel-rich mixture containing extra fuel provides faster chemical reaction kinetics during combustion. Option D correct...

Q5. A stoichiometric air-fuel mixture is defined as______________________?

Select your answer for: A stoichiometric air-fuel mixture is defined as______________________?
Show answer

Answer: A. chemically correct mixture

A stoichiometric air-fuel mixture is defined as the chemically correct ratio required for complete fuel combustion. It contains exactly enough oxygen to burn all available hydrocarbon fuel without leaving excess unburnt...

Q6. Hydraulic turbines are alternatively referred to as : ___________?

Select your answer for: Hydraulic turbines are alternatively referred to as : ___________?
Show answer

Answer: B. water turbines

Hydraulic turbines are commonly known as water turbines because they harness flowing water energy. Water serves as the primary working fluid driving the runner blades in hydroelectric installations. Kinetic and potential...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test