Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57337

Peak flame speed inside a diesel engine occurs at this air-fuel ratio_______________?

Select your answer for: Peak flame speed inside a diesel engine occurs at this air-fuel ratio_______________?
Show answer

Answer: D. about 10% rich mixture

Explanation

Peak flame speed and optimal combustion velocity in engines occur with slightly rich fuel mixtures. A fuel-rich mixture containing extra fuel provides faster chemical reaction kinetics during combustion. Option D correctly points to a mixture approximately ten percent rich for maximum flame speed. Stoichiometric air-fuel ratios provide exact chemical balance without excess fuel or oxygen. Slightly rich mixtures ensure all available oxygen is consumed, maximizing power output. Flame propagation rates drop significantly if mixtures become excessively rich or lean.

Internal combustion engine tuning balances fuel economy against peak power and flame speed. Racing engines often run slightly rich mixtures to maximize power and prevent destructive knocking. Exhaust emissions systems must account for unburned hydrocarbons resulting from rich mixture combustion. Option A uniform distribution describes mixture homogeneity rather than the optimal fuel ratio. Option B chemically correct mixtures yield slightly lower flame speeds than slightly rich ones. Options C and E represent alternative richness levels, but ten percent rich optimizes flame speed.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Hydrometers are utilized to measure____________________?

Select your answer for: Hydrometers are utilized to measure____________________?
Show answer

Answer: A. specific gravity of liquids

Hydrometers are floating glass instruments used to measure the specific gravity of liquids. Archimedes principle dictates that a weighted bulb floats at depths proportional to liquid density. Graduated stems on hydromete...

Q2. Fitting an air vessel to a single-acting reciprocating pump yields work and power savings on the order of__________________?

Select your answer for: Fitting an air vessel to a single-acting reciprocating pump yields work and power savings on the order of__________________?
Show answer

Answer: D. 84.8%

Reciprocating pumps suffer from inertia pressure fluctuations due to accelerated piston motion. Fitting an air vessel absorbs these pulsations and smooths out the cyclical flow rate. Mathematical analysis proves this dam...

Q3. Reaction turbine discharge varies with increased unit speed by____________________?

Select your answer for: Reaction turbine discharge varies with increased unit speed by____________________?
Show answer

Answer: B. decreases

In reaction turbines, fluid discharge decreases as the unit rotational speed increases under constant head. Centrifugal forces generated by the rotating runner create an opposing pressure head that restricts incoming flo...

Q4. Hydraulic turbines are alternatively referred to as : ___________?

Select your answer for: Hydraulic turbines are alternatively referred to as : ___________?
Show answer

Answer: B. water turbines

Hydraulic turbines are commonly known as water turbines because they harness flowing water energy. Water serves as the primary working fluid driving the runner blades in hydroelectric installations. Kinetic and potential...

Q5. Compared to a petrol engine at rated load, a diesel engine exhibits____________________?

Select your answer for: Compared to a petrol engine at rated load, a diesel engine exhibits____________________?
Show answer

Answer: A. more efficient

Diesel engines operate at higher compression ratios and lean mixtures, resulting in superior thermodynamic efficiency. Higher compression and expansion ratios allow diesel units to extract more mechanical work from each...

Q6. Detonation in an internal combustion engine causes this parameter to spike_____________________?

Select your answer for: Detonation in an internal combustion engine causes this parameter to spike_____________________?
Show answer

Answer: B. rate of rise of pressure

Detonation in an internal combustion engine causes an extreme spike in the rate of pressure rise. Unburnt end-gas autoignites simultaneously, generating shockwaves that hammer combustion chamber walls. This abnormal comb...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test