Heat engines operate by utilizing_________________?
Show answer Hide answer
Answer: C. high heat value of oil
Explanation
Heat engines base their thermodynamic energy calculations and fuel ratings on the high heat value of fuel. High heat value, also known as gross calorific value, includes the latent heat released by condensing water vapor. Standard testing protocols for heat engine efficiency utilize this total energy release baseline in calculations. Calorific value represents the total thermal energy released when a unit quantity of fuel burns completely. Combustion of hydrocarbon fuels produces water vapor that carries away thermal energy unless condensed. Thermodynamic efficiency compares useful work output against total chemical energy supplied by the fuel.
Power plant thermodynamic efficiency reports rely on fuel heating values to evaluate overall performance. Comparing diesel and petrol engine performance requires accurate fuel calorific value measurements. Environmental regulations and fuel economy standards depend on standardized energy content testing. Low heat value excludes water condensation energy and is typically used for combustion systems where steam escapes. Mean heat value is not a standard thermodynamic term used for rigorous heat engine fuel ratings. Stating all of the above is incorrect because specific heat engine standards mandate high heat value usage.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Which section of a hydraulic turbine is most vulnerable to cavitation damage__________________?
Show answer Hide answer
Answer: A. inlet of draft rube
The inlet of the draft tube experiences the lowest absolute static pressure within any reaction hydraulic turbine. When local pressure drops below the vapor pressure of water, vapor bubbles form and collapse violently. T...
Q2. Hydrometers are utilized to measure____________________?
Show answer Hide answer
Answer: A. specific gravity of liquids
Hydrometers are floating glass instruments used to measure the specific gravity of liquids. Archimedes principle dictates that a weighted bulb floats at depths proportional to liquid density. Graduated stems on hydromete...
Q3. Fitting an air vessel to a single-acting reciprocating pump yields work and power savings on the order of__________________?
Show answer Hide answer
Answer: D. 84.8%
Reciprocating pumps suffer from inertia pressure fluctuations due to accelerated piston motion. Fitting an air vessel absorbs these pulsations and smooths out the cyclical flow rate. Mathematical analysis proves this dam...
Q4. A stoichiometric air-fuel mixture is defined as______________________?
Show answer Hide answer
Answer: A. chemically correct mixture
A stoichiometric air-fuel mixture is defined as the chemically correct ratio required for complete fuel combustion. It contains exactly enough oxygen to burn all available hydrocarbon fuel without leaving excess unburnt...
Q5. Hydraulic turbines are alternatively referred to as : ___________?
Show answer Hide answer
Answer: B. water turbines
Hydraulic turbines are commonly known as water turbines because they harness flowing water energy. Water serves as the primary working fluid driving the runner blades in hydroelectric installations. Kinetic and potential...
Q6. Compared to a petrol engine at rated load, a diesel engine exhibits____________________?
Show answer Hide answer
Answer: A. more efficient
Diesel engines operate at higher compression ratios and lean mixtures, resulting in superior thermodynamic efficiency. Higher compression and expansion ratios allow diesel units to extract more mechanical work from each...