Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57331

For a piping system primarily consisting of vertical lift with minimal friction, pump characteristics should be_________________?

Select your answer for: For a piping system primarily consisting of vertical lift with minimal friction, pump characteristics should be_________________?
Show answer

Answer: C. steep

Explanation

When static lift dominates piping head, pump performance curves must be steep to maintain flow. A steep head-capacity curve prevents large flow rate swings when minor head variations occur. Option C correctly identifies steep pump characteristics as ideal for high static lift systems. Pump characteristic curves plot total dynamic head against volumetric flow capacity. Friction head losses scale with the square of flow, whereas static lift remains constant. Selecting pumps with appropriate slope prevents motor overloading during variable operating conditions.

Municipal water booster stations pumping to elevated storage tanks require steep pump curves. Irrigation systems with significant elevation changes use steep characteristic pumps for stability. Industrial liquid transfer across tall vertical facilities relies on steep head-capacity profiles. Option A horizontal curves would cause massive flow fluctuations with slight head changes. Option B nearly horizontal curves are unsuitable for systems dominated by high static lift. Options D and E do not describe standard pump characteristic curve requirements for vertical lift.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. The horsepower demand for the aforementioned condition will be___________________?

Select your answer for: The horsepower demand for the aforementioned condition will be___________________?
Show answer

Answer: B. 0.75 B.H.P.

Power demand scales directly with fluid specific gravity in constant volumetric pump applications. Pumping a fluid with 0.75 specific gravity reduces the brake horsepower requirement proportionally to 0.75 B.H.P. Lower f...

Q2. The optimal vane exit angle for a centrifugal pump impeller is_________________?

Select your answer for: The optimal vane exit angle for a centrifugal pump impeller is_________________?
Show answer

Answer: B. 20-25°

Centrifugal pump impellers achieve optimal hydraulic efficiency with specific blade exit angles. Empirical design data shows that vane exit angles between 20 and 25 degrees work best. This angle range minimizes hydraulic...

Q3. An impulse turbine can accommodate a maximum number of jets without interference equal to________________?

Select your answer for: An impulse turbine can accommodate a maximum number of jets without interference equal to________________?
Show answer

Answer: B. 6

An impulse turbine runner can accommodate a maximum of six jets without causing mutual flow interference. Spacing multiple jets around the Pelton wheel circumference ensures exhausted water clears adjacent buckets safely...

Q4. Hydrometers are utilized to measure____________________?

Select your answer for: Hydrometers are utilized to measure____________________?
Show answer

Answer: A. specific gravity of liquids

Hydrometers are floating glass instruments used to measure the specific gravity of liquids. Archimedes principle dictates that a weighted bulb floats at depths proportional to liquid density. Graduated stems on hydromete...

Q5. Fitting an air vessel to a single-acting reciprocating pump yields work and power savings on the order of__________________?

Select your answer for: Fitting an air vessel to a single-acting reciprocating pump yields work and power savings on the order of__________________?
Show answer

Answer: D. 84.8%

Reciprocating pumps suffer from inertia pressure fluctuations due to accelerated piston motion. Fitting an air vessel absorbs these pulsations and smooths out the cyclical flow rate. Mathematical analysis proves this dam...

Q6. Reaction turbine discharge varies with increased unit speed by____________________?

Select your answer for: Reaction turbine discharge varies with increased unit speed by____________________?
Show answer

Answer: B. decreases

In reaction turbines, fluid discharge decreases as the unit rotational speed increases under constant head. Centrifugal forces generated by the rotating runner create an opposing pressure head that restricts incoming flo...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test