Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 56927

Moisture separators in compressed air setups are typically positioned_____________________?

Select your answer for: Moisture separators in compressed air setups are typically positioned_____________________?
Show answer

Answer: D. between after-cooler and air receiver

Explanation

Moisture separators are typically positioned after the after-cooler and before the compressed air receiver. Cooling the air in the after-cooler condenses water vapour, which the separator then traps and drains. Placing the separator here prevents liquid water from entering and accumulating inside the storage receiver. After-coolers reduce compressed air temperature, forcing entrained moisture out of its gaseous suspension. Air receivers store compressed air to dampen pressure pulsations and supply peak factory demand surges. Drain valves on moisture separators remove condensed water automatically from the compressed air system.

Compressed air system layout standards require water separation before storage to prevent tank corrosion. Industrial manufacturing plants install moisture separators to protect downstream air dryers and filters. Pneumatic maintenance technicians inspect separator drains daily to ensure proper removal of condensed water. Positioning separators before the intercooler would miss moisture condensed later in the after-cooler. Putting separators after the intercooler but before the after-cooler misses downstream condensation drops. Placing the separator after the receiver allows moisture to accumulate inside the storage tank first.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Compressor surging behavior describes the phenomenon of___________________?

Select your answer for: Compressor surging behavior describes the phenomenon of___________________?
Show answer

Answer: C. unsteady, periodic and reversed flow

Compressor surging describes an unstable aerodynamic phenomenon in rotating machinery. Unsteady, periodic, and reversed flow characterize severe compressor surge events. Flow breakdown causes the entire air mass in the s...

Q2. The ratio comparing indicated power output to shaft power output is termed__________________?

Select your answer for: The ratio comparing indicated power output to shaft power output is termed__________________?
Show answer

Answer: D. mechanical efficiency

Mechanical efficiency compares the useful shaft power output to the indicated power generated internally. Friction losses in bearings, seals, and auxiliary pumps reduce the net usable shaft power output. Dividing measure...

Q3. Implementing reheating stages in gas turbine systems produces___________________?

Select your answer for: Implementing reheating stages in gas turbine systems produces___________________?
Show answer

Answer: D. both A. and B. above

Reheating in gas turbines involves expanding gas through a high-pressure turbine and reheating it before a second turbine. This additional heat input increases the total net work output relative to the total mass flow an...

Q4. Reciprocating air compressors prove most advantageous for___________________?

Select your answer for: Reciprocating air compressors prove most advantageous for___________________?
Show answer

Answer: A. large quantity of air at high pressure

Reciprocating compressors are designed to deliver smaller volumetric quantities at high delivery pressures.

Q5. How does incoming air velocity in a rocket motor compare to that in an atmospheric jet aircraft_________________?

Select your answer for: How does incoming air velocity in a rocket motor compare to that in an atmospheric jet aircraft_________________?
Show answer

Answer: D. zero

Rocket motors carry onboard oxidizers and do not ingest atmospheric air supplies. Incoming atmospheric air velocity relative to internal combustion is effectively zero. Chemical propellant reactions occur entirely within...

Q6. Select the valid statement among the options ?

Select your answer for: Select the valid statement among the options ?
Show answer

Answer: C. gas .turbine’s blade will appear as impulse section at the hub and as a reaction section at tip

Due to changing blade speeds from hub to tip, gas turbine blades are twisted. This aerodynamic twist causes blades to act as impulse sections at the root and reaction sections. Radial variations in tangential velocity re...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test