Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 56931

Select the valid statement among the options ?

Select your answer for: Select the valid statement among the options ?
Show answer

Answer: C. gas .turbine’s blade will appear as impulse section at the hub and as a reaction section at tip

Explanation

Due to changing blade speeds from hub to tip, gas turbine blades are twisted. This aerodynamic twist causes blades to act as impulse sections at the root and reaction sections. Radial variations in tangential velocity require variable blade profile designs from hub to tip. Gas turbine blade design involves complex three-dimensional fluid dynamics and aerodynamic loading principles. Hub sections operate at lower linear speeds, requiring higher flow turning angles like impulse turbines. Tip sections move much faster, utilizing aerodynamic lift profiles characteristic of reaction blading.

Modern aero-engine turbine blades are precision-cast with complex internal cooling passages and twist profiles. Aerospace manufacturers use advanced computational fluid dynamics to optimize turbine blade root-to-tip shapes. Proper blade design prevents boundary layer separation and maximizes energy extraction from hot gases. Option A is incorrect because large gas turbines utilize axial flow turbines rather than radial ones. Option B is too general and overlooks the specific aerodynamic differences from steam turbines. Option D describes cooling methods but fails to explain the specific blade cross-section geometry.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Moisture separators in compressed air setups are typically positioned_____________________?

Select your answer for: Moisture separators in compressed air setups are typically positioned_____________________?
Show answer

Answer: D. between after-cooler and air receiver

Moisture separators are typically positioned after the after-cooler and before the compressed air receiver. Cooling the air in the after-cooler condenses water vapour, which the separator then traps and drains. Placing t...

Q2. Gas turbine rotor blades are fabricated from_________________?

Select your answer for: Gas turbine rotor blades are fabricated from_________________?
Show answer

Answer: E. high nicket alloy (neimonic)

Rotor blades face severe centrifugal stresses and extremely high combustion temperatures. High-nickel superalloys retain their mechanical strength and creep resistance near melting points. Nimonic alloys are specifically...

Q3. Reciprocating air compressors prove most advantageous for___________________?

Select your answer for: Reciprocating air compressors prove most advantageous for___________________?
Show answer

Answer: A. large quantity of air at high pressure

Reciprocating compressors are designed to deliver smaller volumetric quantities at high delivery pressures.

Q4. Why is a diverging inlet duct utilized in a jet propulsion power unit_______________ ?

Select your answer for: Why is a diverging inlet duct utilized in a jet propulsion power unit_______________ ?
Show answer

Answer: B. convert kinetic energy of air into pres-sure energy

A diverging inlet duct functions as a aerodynamic diffuser that slows down incoming high-speed air safely. Slowing the air velocity converts its kinetic energy into static pressure energy prior to entering the compressor...

Q5. How does terminal gas temperature at compression end compare to exhaust temperatures in a gas turbine_________________?

Select your answer for: How does terminal gas temperature at compression end compare to exhaust temperatures in a gas turbine_________________?
Show answer

Answer: B. lower

The terminal gas temperature at the end of compression is lower than post-combustion exhaust temperatures. Combustion adds immense thermal energy that raises gas temperatures far above peak compression levels. Comparing...

Q6. Rotary compressor designs are well-suited for____________________?

Select your answer for: Rotary compressor designs are well-suited for____________________?
Show answer

Answer: C. large discharge at low pressure

Rotary compressors use continuous rotational motion to move high volumes of fluid. Their internal flow paths are designed for high volumetric discharge rates smoothly. Structural limitations restrict high-pressure sealin...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test