Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 56928

Gas turbine rotor blades are fabricated from_________________?

Select your answer for: Gas turbine rotor blades are fabricated from_________________?
Show answer

Answer: E. high nicket alloy (neimonic)

Explanation

Rotor blades face severe centrifugal stresses and extremely high combustion temperatures. High-nickel superalloys retain their mechanical strength and creep resistance near melting points. Nimonic alloys are specifically engineered to withstand these harsh operating environments. Creep is the slow permanent deformation of metals under prolonged high temperature stress. Nickel-chromium superalloys form protective oxide scales preventing rapid high-temperature corrosion. Single-crystal casting techniques eliminate grain boundaries to further strengthen turbine blades.

Advanced jet engines use internal cooling air passages inside blades to prevent failure. Metallurgical limits of turbine blades restrict maximum possible gas turbine operating temperatures. Material science innovations directly enable higher thrust ratings in modern aviation. Mild steel would lose its structural integrity and melt rapidly in turbine sections. Carbon steel lacks the high-temperature oxidation resistance required for turbine blades. Stainless steel is unsuitable for the extreme thermal loads found in modern turbines.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. The ratio comparing indicated power output to shaft power output is termed__________________?

Select your answer for: The ratio comparing indicated power output to shaft power output is termed__________________?
Show answer

Answer: D. mechanical efficiency

Mechanical efficiency compares the useful shaft power output to the indicated power generated internally. Friction losses in bearings, seals, and auxiliary pumps reduce the net usable shaft power output. Dividing measure...

Q2. Implementing reheating stages in gas turbine systems produces___________________?

Select your answer for: Implementing reheating stages in gas turbine systems produces___________________?
Show answer

Answer: D. both A. and B. above

Reheating in gas turbines involves expanding gas through a high-pressure turbine and reheating it before a second turbine. This additional heat input increases the total net work output relative to the total mass flow an...

Q3. Reheating working fluids across multi-stage expansion gas turbines leads to____________________?

Select your answer for: Reheating working fluids across multi-stage expansion gas turbines leads to____________________?
Show answer

Answer: D. maximum work output

Reheating working fluids between turbine expansion stages adds thermal energy back into the gas stream. Adding heat during expansion increases the specific volume of the gas, allowing it to perform more work on subsequen...

Q4. How does incoming air velocity in a rocket motor compare to that in an atmospheric jet aircraft_________________?

Select your answer for: How does incoming air velocity in a rocket motor compare to that in an atmospheric jet aircraft_________________?
Show answer

Answer: D. zero

Rocket motors carry onboard oxidizers and do not ingest atmospheric air supplies. Incoming atmospheric air velocity relative to internal combustion is effectively zero. Chemical propellant reactions occur entirely within...

Q5. Select the valid statement among the options ?

Select your answer for: Select the valid statement among the options ?
Show answer

Answer: C. gas .turbine’s blade will appear as impulse section at the hub and as a reaction section at tip

Due to changing blade speeds from hub to tip, gas turbine blades are twisted. This aerodynamic twist causes blades to act as impulse sections at the root and reaction sections. Radial variations in tangential velocity re...

Q6. Closed-loop gas turbine cycles are characterized by_________________?

Select your answer for: Closed-loop gas turbine cycles are characterized by_________________?
Show answer

Answer: A. provides greater flexibility

Closed-loop gas turbine cycles circulate a clean working fluid continuously through a sealed closed circuit. Because the working gas does not contact combustion products, clean alternative gases like helium can be utiliz...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test