Reheating working fluids across multi-stage expansion gas turbines leads to____________________?
Show answer Hide answer
Answer: D. maximum work output
Explanation
Reheating working fluids between turbine expansion stages adds thermal energy back into the gas stream. Adding heat during expansion increases the specific volume of the gas, allowing it to perform more work on subsequent turbine blades. Multi-stage expansion with reheating elevates the total cumulative work output generated by the gas turbine system. Reheat is commonly implemented in high-pressure power generation gas turbines and steam turbine power plants. Expanding gas cools down significantly; reheating restores temperature levels to maintain high pressure drops across later stages. Turbine work output represents the area under the expansion curve on a thermodynamic property diagram.
Thermal efficiency does not automatically reach high levels with reheat alone unless combined with regeneration techniques. Reducing compressor work is accomplished through intercooling rather than reheating the working fluid during expansion. Decreasing exhaust heat loss is achieved through heat exchangers like regenerators rather than turbine stage reheating.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Gas turbine machinery operates on the thermodynamic cycle of______________?
Show answer Hide answer
Answer: A. Brayton or Atkinson cycle
Gas turbine engines operate on continuous steady-flow thermodynamic power cycles. The Brayton cycle consists of isentropic compression, isobaric heat addition, and expansion. The Atkinson cycle shares similar closed-loop...
Q2. Compressor surging behavior describes the phenomenon of___________________?
Show answer Hide answer
Answer: C. unsteady, periodic and reversed flow
Compressor surging describes an unstable aerodynamic phenomenon in rotating machinery. Unsteady, periodic, and reversed flow characterize severe compressor surge events. Flow breakdown causes the entire air mass in the s...
Q3. The ratio comparing indicated power output to shaft power output is termed__________________?
Show answer Hide answer
Answer: D. mechanical efficiency
Mechanical efficiency compares the useful shaft power output to the indicated power generated internally. Friction losses in bearings, seals, and auxiliary pumps reduce the net usable shaft power output. Dividing measure...
Q4. Gas turbine rotor blades are fabricated from_________________?
Show answer Hide answer
Answer: E. high nicket alloy (neimonic)
Rotor blades face severe centrifugal stresses and extremely high combustion temperatures. High-nickel superalloys retain their mechanical strength and creep resistance near melting points. Nimonic alloys are specifically...
Q5. Reciprocating air compressors prove most advantageous for___________________?
Show answer Hide answer
Answer: A. large quantity of air at high pressure
Reciprocating compressors are designed to deliver smaller volumetric quantities at high delivery pressures.
Q6. How does incoming air velocity in a rocket motor compare to that in an atmospheric jet aircraft_________________?
Show answer Hide answer
Answer: D. zero
Rocket motors carry onboard oxidizers and do not ingest atmospheric air supplies. Incoming atmospheric air velocity relative to internal combustion is effectively zero. Chemical propellant reactions occur entirely within...