Implementing reheating stages in gas turbine systems produces___________________?
Show answer Hide answer
Answer: D. both A. and B. above
Explanation
Reheating in gas turbines involves expanding gas through a high-pressure turbine and reheating it before a second turbine. This additional heat input increases the total net work output relative to the total mass flow and compression work. However, because heat is added at lower average temperatures, overall thermal efficiency generally decreases. Gas turbine reheating raises the overall work ratio by increasing turbine output work relative to compressor work. Thermal efficiency is defined as net work output divided by total heat energy supplied to the fuel system. Without a regenerator, adding reheat fuel increases total heat input and lowers overall cycle thermal efficiency.
Option A mentions work ratio increase, but misses the accompanying drop in thermal efficiency. Option B notes the efficiency decrease, but overlooks the simultaneous increase in work ratio. Option C claims a work ratio decrease, which contradicts the actual thermodynamic work output enhancement.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Ram compression effects occurring in turbojet inlets entail____________________?
Show answer Hide answer
Answer: A. reduction of speed of incoming air and conversion of part of it into pressure energy
Ram compression in turbojet inlets decelerates high-speed incoming air to convert kinetic energy into pressure. This deceleration raises static pressure without requiring mechanical compressor work from the engine core....
Q2. Gas turbine machinery operates on the thermodynamic cycle of______________?
Show answer Hide answer
Answer: A. Brayton or Atkinson cycle
Gas turbine engines operate on continuous steady-flow thermodynamic power cycles. The Brayton cycle consists of isentropic compression, isobaric heat addition, and expansion. The Atkinson cycle shares similar closed-loop...
Q3. Compressor surging behavior describes the phenomenon of___________________?
Show answer Hide answer
Answer: C. unsteady, periodic and reversed flow
Compressor surging describes an unstable aerodynamic phenomenon in rotating machinery. Unsteady, periodic, and reversed flow characterize severe compressor surge events. Flow breakdown causes the entire air mass in the s...
Q4. Moisture separators in compressed air setups are typically positioned_____________________?
Show answer Hide answer
Answer: D. between after-cooler and air receiver
Moisture separators are typically positioned after the after-cooler and before the compressed air receiver. Cooling the air in the after-cooler condenses water vapour, which the separator then traps and drains. Placing t...
Q5. Gas turbine rotor blades are fabricated from_________________?
Show answer Hide answer
Answer: E. high nicket alloy (neimonic)
Rotor blades face severe centrifugal stresses and extremely high combustion temperatures. High-nickel superalloys retain their mechanical strength and creep resistance near melting points. Nimonic alloys are specifically...
Q6. Reciprocating air compressors prove most advantageous for___________________?
Show answer Hide answer
Answer: A. large quantity of air at high pressure
Reciprocating compressors are designed to deliver smaller volumetric quantities at high delivery pressures.