Kirchhoff’s law dictates that______________________?
Show answer Hide answer
Answer: E. ratio of emissive power to absorptive power for all bodies is same and is equal to the emissive power of a perfectly black body
Explanation
Kirchhoff's law states that any body's ratio of emissive power to absorptivity equals a black body's emissive power. This fundamental radiation law applies at any given thermal equilibrium temperature for all radiating surfaces. Good absorbers of thermal radiation are consequently also good emitters at the same temperature. Emissive power is the rate at which thermal radiation energy is emitted per unit surface area. Absorptivity is the fraction of incident radiation energy absorbed by a material surface. A black body is an idealized physical object that absorbs all incident radiation without reflection.
The fourth power temperature proportionality describes Stefan-Boltzmann law rather than Kirchhoff's emission ratio law. Emissive power depending on temperature is true but fails to capture the complete ratio definition in the law. Stating the ratio is maximum for black bodies is incorrect because the ratio equals the black body emissive power.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. A thermally transparent body reflects 40% of incident radiant energy. Given a transmissivity of 0.15, its surface emissivity is____________________?
Show answer Hide answer
Answer: A. 0.45
Radiation energy balance requires the sum of reflectivity, transmissivity, and absorptivity to equal exactly one. Subtracting the 40 percent reflectivity and 15 percent transmissivity leaves an absorptivity of 45 percent...
Q2. A grey body is defined as one where absorptivity_________________?
Show answer Hide answer
Answer: C. is equal to its emissivity
By definition, a grey body has an absorptivity that equals its emissivity across all conditions. Its radiative properties remain constant and do not vary with wavelength or temperature changes. This idealized engineering...
Q3. Boiler fusible plugs are made of a low-melting alloy comprising tin, lead, and___________________?
Show answer Hide answer
Answer: A. bismuth
Boiler fusible plugs utilize low melting point ternary metal alloys for emergency safety. Bismuth combines with tin and lead to depress the alloy melting temperature significantly. Excessive boiler temperatures melt the...
Q4. The free liquid surface acts like a membrane and tends to shrink to minimum area due to_________________?
Show answer Hide answer
Answer: B. force of cohesion
Cohesive forces act between identical liquid molecules, pulling them inward and minimizing the exposed surface area. This molecular attraction creates an inward pressure that forces liquid droplets to form spherical shap...
Q5. Grey cast iron is characterized by_____________________?
Show answer Hide answer
Answer: A. contains 1.7 to 3.5% carbon in free state and is obtained by the slow cooling of molten cast iron
Grey cast iron contains 1.7 to 3.5% free graphite flakes formed during slow cooling of molten metal. These graphite flakes give the fractured metal a characteristic grey appearance and dampen vibrations well. Slow coolin...
Q6. A rising temperature of flue gases entering the chimney at constant steam output indicates__________________?
Show answer Hide answer
Answer: C. fouling of heat transfer surfaces
Fouling layers act as thermal insulators on boiler heat transfer tube surfaces. Insulating deposits prevent heat from transferring effectively into the circulating boiler water. Consequently, waste heat escapes up the ch...