The effort required to elevate a load W using a screw jack with helix angle a and friction angle <j) equals _________________?
Show answer Hide answer
Answer: A. Wtan(a + )
Explanation
The effort required to lift a load using a screw jack with helix and friction angles is given by W tan(alpha + phi). This mathematical formula incorporates the helix angle to account for lead and the friction angle for contact resistance. Multiplying the load by the tangent of the combined angles yields the exact lifting effort force needed. A screw jack is a mechanical lifting device that converts rotational torque into linear upward load movement. The helix angle describes the steepness of the screw thread spiral relative to a plane perpendicular to the axis. Friction between the mating threads of the screw and nut generates significant resistance during load elevation.
Option B calculates the effort required to lower the load rather than elevate it. Option C and D use trigonometric sine and cosine functions which do not correctly model thread friction mechanics. Option E is an incorrect formula that fails to account for thread helix and friction angles properly.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. The inclination angle of a slope when an object resting on it begins sliding downward is termed the angle of_______________?
Show answer Hide answer
Answer: C. repose
The angle of repose is the maximum inclination angle where an object remains stationary without sliding. When the slope exceeds this specific angle, gravitational forces overcome static friction, causing sliding. It prov...
Q2. A uniform lamina's center of gravity is positioned at____________________?
Show answer Hide answer
Answer: C. the mid point of its axis
A uniform lamina possesses symmetric mass distribution across its geometric area. The center of gravity for such symmetrical shapes lies directly on its central axis. For a uniform geometric lamina, it sits precisely at...
Q3. The coefficient of friction relies upon_______________?
Show answer Hide answer
Answer: A. nature of surfaces
The coefficient of friction primarily depends on the material composition and physical nature of the contacting surfaces. Surface roughness, microscopic bonding, and chemical contamination dictate how strongly two materi...
Q4. The peak frictional resistance that arises just as an object starts sliding across a surface is termed__________________?
Show answer Hide answer
Answer: A. limiting friction
Limiting friction is the maximum frictional force that must be overcome as sliding begins. It represents the peak threshold between stationary static friction and active sliding kinetic friction. Exceeding this limiting...
Q5. How does the mass moment of inertia of a hollow circular section about a central perpendicular axis compare to its inertia about a horizontal axis__________________?
Show answer Hide answer
Answer: B. double
The polar mass moment of inertia equals the sum of two orthogonal transverse components. For a symmetric circular section, the two transverse components are completely equal to each other. Therefore doubling the transver...
Q6. The friction coefficient is defined as the_________________?
Show answer Hide answer
Answer: B. ratio of limiting friction and normal reaction
The coefficient of friction is defined as the ratio of the limiting friction force to the normal reaction force. Dividing the maximum frictional resistance just before sliding begins by the perpendicular pressing force y...