How does gas turbine thermal efficiency compare against stationary diesel power plants__________________?
Show answer Hide answer
Answer: C. less
Explanation
Simple-cycle gas turbines generally achieve lower peak thermal efficiencies compared to large stationary diesel engines. Diesel power plants benefit from extremely high compression ratios that yield superior thermodynamic efficiency levels. Exhaust temperatures in gas turbines remain very high, carrying away substantial unrecovered thermal energy. Thermal efficiency measures how effectively an engine converts supplied fuel energy into useful mechanical work. Stationary diesel engines operate on compression ignition principles with high expansion ratios for maximum efficiency. Gas turbines often utilize cogeneration or combined cycle setups to capture waste heat and boost efficiency.
Power plant operators compare thermal efficiencies when deciding between diesel generators and simple-cycle gas turbines. Base-load electricity generation favors highly efficient diesel or combined-cycle systems to minimize daily fuel expenses. Simple-cycle gas turbines are typically reserved for peak load generation due to their rapid startup capabilities. Claiming gas turbines have more efficiency contradicts established thermodynamic performance data for simple cycles. Stating efficiencies are the same ignores the superior compression ratio advantages inherent in diesel power plants. Saying performance depends on other factors obscures the consistent thermodynamic efficiency advantage of stationary diesels.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Work ratio characteristics of simple gas turbine cycles are governed by_________________?
Show answer Hide answer
Answer: D. all of the above
The work ratio of a simple gas turbine cycle is influenced by the pressure ratio, maximum cycle temperature, and minimum cycle temperature. Net work output and compressor work requirements both depend directly on the ope...
Q2. An optimal pressure ratio exists where gas turbine thermal efficiency peaks. As turbine entry temperatures rise, this peak efficiency pressure ratio will__________________?
Show answer Hide answer
Answer: C. increase
Higher turbine entry temperatures allow the gas turbine to operate more efficiently at higher pressure ratios. As metallurgical limits increase, the optimal pressure ratio for peak thermal efficiency shifts upward. Therm...
Q3. Which material characteristic is most vital for gas turbine blade applications___________________?
Show answer Hide answer
Answer: C. creep
Gas turbine blades operate under high centrifugal stress at elevated temperatures making creep resistance vital. Creep causes permanent plastic deformation of metal components under prolonged mechanical stress at high th...
Q4. Branch piping connections off main compressed air headers should originate where to prevent moisture contamination_________________?
Show answer Hide answer
Answer: A. top side of main
Branch lines should always connect to the top side of main compressed air headers to prevent accumulated condensation and moisture at the bottom from flowing into the branch. Condensate naturally separates from compresse...
Q5. Axial thrust forces acting on a centrifugal compressor rotor originate from________________?
Show answer Hide answer
Answer: B. axial component
Axial thrust in a centrifugal compressor is generated by pressure differentials across axial projected areas. The axial component of aerodynamic forces pushes against the impeller shroud and hub surfaces. Unbalanced pres...
Q6. What is the volumetric efficiency of a clearance-free compressor________________?
Show answer Hide answer
Answer: C. is not dependent upon compressin ratio
In a theoretical clearance-free compressor all trapped air is expelled during the discharge stroke completely. This complete expulsion eliminates the re-expansion of residual clearance gases during the subsequent intake...