Which material characteristic is most vital for gas turbine blade applications___________________?
Show answer Hide answer
Answer: C. creep
Explanation
Gas turbine blades operate under high centrifugal stress at elevated temperatures making creep resistance vital. Creep causes permanent plastic deformation of metal components under prolonged mechanical stress at high thermal levels. Selecting materials that resist this slow degradation prevents catastrophic turbine blade failure during continuous operation. Gas turbine inlet temperatures often exceed the melting point of standard uncooled metal alloy structures. Centrifugal forces pull outward on rotating blades with immense magnitude during high-speed engine operation. Superalloys containing nickel and cobalt are specially engineered to withstand extreme temperatures and mechanical loads.
Option A is incorrect because basic material toughness addresses impact resistance rather than sustained high temperature deformation. Option B is secondary since cyclic fatigue is managed alongside creep but is not the most critical thermal failure mode. Option D and E are important material properties but do not dictate high-temperature load-bearing capacity as strongly as creep.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. How does the weight-to-horsepower ratio of gas turbines compare against piston engines and steam turbines________________?
Show answer Hide answer
Answer: C. lower
Gas turbines generate immense power output relative to their compact physical dimensions and low mass. This high power density results in a much lower weight-to-horsepower ratio than traditional piston engines. Continuou...
Q2. How does a simple gas turbine's thermal efficiency at a set inlet temperature respond to rising pressure ratios_____________________?
Show answer Hide answer
Answer: A. increases
Higher pressure ratios expand the temperature and pressure limits of the Brayton cycle. Expanding cycle limits increases the thermal efficiency according to thermodynamic laws. Heat addition occurs at higher average temp...
Q3. Work ratio characteristics of simple gas turbine cycles are governed by_________________?
Show answer Hide answer
Answer: D. all of the above
The work ratio of a simple gas turbine cycle is influenced by the pressure ratio, maximum cycle temperature, and minimum cycle temperature. Net work output and compressor work requirements both depend directly on the ope...
Q4. How does gas turbine thermal efficiency compare against stationary diesel power plants__________________?
Show answer Hide answer
Answer: C. less
Simple-cycle gas turbines generally achieve lower peak thermal efficiencies compared to large stationary diesel engines. Diesel power plants benefit from extremely high compression ratios that yield superior thermodynami...
Q5. Compressor volumetric efficiency degrades by roughly what amount per 100 m elevation gain___________________?
Show answer Hide answer
Answer: C. 1.0%
Higher elevation decreases ambient air density and atmospheric pressure significantly. Lower air density reduces the mass of air entering the compressor cylinder. Volumetric efficiency degrades by approximately one perce...
Q6. Branch piping connections off main compressed air headers should originate where to prevent moisture contamination_________________?
Show answer Hide answer
Answer: A. top side of main
Branch lines should always connect to the top side of main compressed air headers to prevent accumulated condensation and moisture at the bottom from flowing into the branch. Condensate naturally separates from compresse...