Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57152

Gamma iron is present at the following temperature___________________?

Select your answer for: Gamma iron is present at the following temperature___________________?
Show answer

Answer: D. between 910°C and 1400°C

Explanation

Gamma iron, also known as austenite, exists stably between nine hundred ten and fourteen hundred degrees Celsius. At these elevated temperatures, the iron crystal lattice rearranges into a face-centered cubic structure. This allotropic phase is critical for dissolving carbon during the heat treatment of carbon steels. Iron exhibits different crystal structures at varying temperatures, a phenomenon known as allotropy. Austenite forms when heating plain carbon steel above the lower critical transformation temperature. Understanding iron phase boundaries allows metallurgists to control hardening and annealing processes.

Heat treating steel requires heating it into the gamma iron phase to dissolve carbon before quenching. Forging and rolling operations are often performed while the steel is in the austenite crystal phase. Stainless steel alloys use specific elements to retain austenite structure down to room temperature. Room temperature iron exists in the alpha ferrite crystal phase rather than gamma iron austenite. Temperatures near the melting point involve delta iron rather than the intermediate gamma iron phase. The range between fourteen hundred and fifteen thirty nine degrees Celsius corresponds to delta iron stability.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Gasoline typically freezes at what temperature__________________?

Select your answer for: Gasoline typically freezes at what temperature__________________?
Show answer

Answer: D. less than – 30°C

Gasoline is a complex mixture of hydrocarbons with a very low freezing point, remaining liquid well below minus thirty degrees Celsius. The diverse volatile compounds composing commercial gasoline prevent the formation o...

Q2. The Froude number holds significance in__________________?

Select your answer for: The Froude number holds significance in__________________?
Show answer

Answer: C. simultaneous motion through two fluids where there is a surface of dis-continuity, gravity forces, and wave making effect, as with ship’s hulls

The Froude number characterizes fluid flow with simultaneous gravitational forces and free surface wave effects. It represents the ratio of inertial forces to gravitational forces acting on fluid elements near boundaries...

Q3. Lower load operations make this engine choice more economical_______________?

Select your answer for: Lower load operations make this engine choice more economical_______________?
Show answer

Answer: B. C.I. engine

Compression ignition engines maintain higher thermal efficiency at part loads compared to spark ignition engines. C.I. engines control power output by varying fuel injection quantities while maintaining unthrottled air i...

Q4. Due to the influence of _______________, the free surface of a liquid naturally tends to shrink into the smallest possible area.

Select your answer for: Due to the influence of _______________, the free surface of a liquid naturally tends to shrink into the smallest possible area.
Show answer

Answer: A. surface tension

Surface tension creates a tensile membrane effect on liquid surfaces, causing them to shrink to the smallest possible area. Cohesive intermolecular forces pull surface molecules inward toward the bulk liquid, creating in...

Q5. German silver is composed of_________________?

Select your answer for: German silver is composed of_________________?
Show answer

Answer: C. 5% silver

German silver is historically classified as a copper-nickel-zinc alloy containing approximately five percent silver appearance. Despite its deceptive trade name, the alloy frequently contains no precious silver in standa...

Q6. The arrest points for iron's allotropic modifications are located at __________________?

Select your answer for: The arrest points for iron's allotropic modifications are located at __________________?
Show answer

Answer: D. the points of discontinuity

Allotropic transformations in metals are marked by thermal arrest points where phase changes and structural reorganizations occur. During these critical temperature points heat is absorbed or released without changing th...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test