For dynamic similarity, besides geometric resemblance between model and prototype, this parameter must also match____________________?
Show answer Hide answer
Answer: D. all the four ratios of inertial force to force due to viscosity, gravitation, sur-face tension, and elasticity
Explanation
Dynamic similarity requires matching geometric resemblance and all relevant dimensionless force ratios simultaneously. Inertial forces must scale proportionally with viscous, gravitational, surface tension, and elastic forces. Matching these four specific force ratios ensures fluid flow behavior scales accurately from model to prototype. Dimensional analysis provides scaling laws for testing physical models in wind tunnels and water flumes. Dynamic similarity builds upon geometric and kinematic similarity to include forces acting on the fluid. Dimensionless numbers like Reynolds, Froude, Weber, and Mach represent these critical force ratios.
Aerospace engineers test scaled aircraft models in wind tunnels by matching Reynolds and Mach numbers. Ship model testing in towing tanks requires matching Froude numbers to simulate wave-making resistance. Hydraulic engineers rely on dynamic similarity laws to predict spillway and turbine performance accurately. Matching only viscosity ratios ignores gravity, surface tension, and elasticity forces in complex flows. Limiting similarity to gravitational force ratios fails to account for viscous and compressible effects. Focusing solely on surface tension overlooks primary inertial and viscous forces in fluid scaling.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Due to the influence of _______________, the free surface of a liquid naturally tends to shrink into the smallest possible area.
Show answer Hide answer
Answer: A. surface tension
Surface tension creates a tensile membrane effect on liquid surfaces, causing them to shrink to the smallest possible area. Cohesive intermolecular forces pull surface molecules inward toward the bulk liquid, creating in...
Q2. German silver is composed of_________________?
Show answer Hide answer
Answer: C. 5% silver
German silver is historically classified as a copper-nickel-zinc alloy containing approximately five percent silver appearance. Despite its deceptive trade name, the alloy frequently contains no precious silver in standa...
Q3. The arrest points for iron's allotropic modifications are located at __________________?
Show answer Hide answer
Answer: D. the points of discontinuity
Allotropic transformations in metals are marked by thermal arrest points where phase changes and structural reorganizations occur. During these critical temperature points heat is absorbed or released without changing th...
Q4. Free cutting steels are known for_____________________?
Show answer Hide answer
Answer: A. are used where ease in machining is the criterion
Free-cutting steels are specially alloyed with elements like sulfur or lead to improve machinability and chip breaking. These additive inclusions create microscopic discontinuities in the steel matrix that cause metal ch...
Q5. An increase in back pressure will cause fuel consumption to________________?
Show answer Hide answer
Answer: A. increase
An increase in exhaust back pressure restricts the smooth expulsion of combustion gases from the engine cylinder. Residual trapped exhaust gases dilute the incoming fresh air-fuel charge, reducing volumetric efficiency a...
Q6. Expanding steam down to an extremely low pressure (high vacuum) within steam engines is_________________?
Show answer Hide answer
Answer: E. uneconomical
Expanding steam to extremely high vacuums increases equipment size and condensation losses disproportionately. The specific volume of steam increases exponentially at very low pressures requiring massive low-pressure cyl...