During a polytropic thermodynamic expansion or compression_________________?
Show answer Hide answer
Answer: D. all of the above
Explanation
Polytropic processes involve simultaneous heat transfer, mechanical work, and property state changes in gases. Working fluids can shift between wet, dry, or superheated states during polytropic expansion or compression. Energy conservation principles dictate that both work and heat crossing system boundaries occur during these cycles. A polytropic process follows the generalized thermodynamic path equation where pressure times volume to the power of n is constant. Real-world compressors and turbines operate polytropically because heat transfer through cylinder walls is never zero. Thermodynamic property tables are used to track steam or gas state changes throughout expansion and compression.
Selecting only heat transfer ignores the essential mechanical work and phase changes happening simultaneously. Focusing exclusively on work done neglects the crucial heat transfer and fluid state variations that also occur. Stating none of the above is incorrect because all listed phenomena are valid characteristics of polytropic processes.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. A motor flywheel accelerates from a standstill to 1000 rpm over 6 seconds. Approximately how many complete revolutions does it execute___________________?
Show answer Hide answer
Answer: B. 50
Integrating angular velocity over the six-second acceleration period from rest to one thousand revolutions per minute yields a total displacement of approximately fifty complete revolutions. Assuming constant angular acc...
Q2. Fluid flow behavior while progressively opening a pipeline valve is classified as_________________?
Show answer Hide answer
Answer: B. unsteady
Fluid flow parameters change with time while a valve is being progressively opened or closed. This temporal variation in velocity and pressure classifies the fluid flow regime as unsteady. Steady flow requires that fluid...
Q3. Thermal cycle efficiency is elevated by________________?
Show answer Hide answer
Answer: C. both A. and B.
Both steam regeneration and reheating improve the overall thermal efficiency of steam power cycles. Regeneration preheats boiler feed water using extracted steam to reduce external heat addition requirements. Reheating s...
Q4. A heavy ladder supported on a floor against a vertical wall may lose equilibrium if____________________?
Show answer Hide answer
Answer: C. the floor and wall both are smooth surfaces
If both the floor and the wall are perfectly smooth, no frictional forces can exist to oppose sliding, causing the ladder to lose equilibrium and slip. Static equilibrium requires balancing horizontal and vertical forces...
Q5. A flexible cable suspended between two supports at identical elevations with minimal sag approximates the geometric curve of____________________?
Show answer Hide answer
Answer: B. parabola
A flexible cable carrying a uniformly distributed load along its horizontal span takes the shape of a parabola. When suspension bridges support deck loads uniformly along the horizontal axis, cables form parabolic curves...
Q6. A projectile launched at an angle 9 relative to the vertical achieves its maximum horizontal range when 9 equals_______________?
Show answer Hide answer
Answer: C. 45°
For a projectile launched from level ground maximum horizontal range is achieved at a launch angle of forty-five degrees. This optimal angle balances the initial vertical velocity component needed for flight time with ho...