Ductile cast iron exhibits___________________?
Show answer Hide answer
Answer: D. is produced by small additions of magnesium (or creium) in the ladle. Graphite is in nodular or spheroidal form and is well dispersed throughout the material
Explanation
Ductile cast iron is produced by inoculating molten iron with magnesium or cerium, causing the graphite to form microscopic nodules that improve toughness. The nodular or spheroidal shape of the graphite particles prevents the formation of sharp internal stress concentration cracks. This unique microstructure gives ductile iron high tensile strength and impact resistance comparable to certain carbon steels. Standard grey cast iron contains graphite in flake form, which makes the metal brittle and weak under tension. Adding trace amounts of magnesium or cerium modifies the graphite precipitation process during solidification of the molten iron. Heat treatment and precise chemical control are necessary to ensure consistent nodular formation throughout the casting.
Containing carbon in a free state from slow cooling describes standard grey cast iron rather than modified ductile iron. Chilled cast iron is produced by rapid surface cooling to create an extremely hard, unmachinable wear-resistant layer. Metals produced by standard annealing processes resulting in soft, tough structures describe malleable cast iron.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Industrial water gas is manufactured via ___________________ ?
Show answer Hide answer
Answer: B. passing steam over incandescent coke
Water gas is produced industrially by passing steam over hot incandescent coke at high temperatures. This endothermic chemical reaction produces a clean synthesis gas composed primarily of carbon monoxide and hydrogen. T...
Q2. Dowmetal alloy compositions contain____________________?
Show answer Hide answer
Answer: D. 90% magnesium and 9% aluminium with some copper
Dowmetal alloys are a family of lightweight magnesium-based engineering materials containing roughly ninety percent magnesium. Approximately nine percent aluminum is alloyed with the magnesium base to enhance strength an...
Q3. Differential U-tube manometers are applied to measure___________________?
Show answer Hide answer
Answer: D. difference of pressure between two points
A differential U-tube manometer measures the pressure difference between two separate points in a fluid system. The fluid level displacement inside the U-tube corresponds directly to the applied pressure gradient. It eli...
Q4. A mass W resting on an inclined plane is on the verge of being pulled upward by a horizontal pull P. This motion impends when P equates to________________?
Show answer Hide answer
Answer: C. Wtan(a + <|))
The pulling force required to move a body up an inclined plane is determined by weight and friction angles. Resolving forces parallel and perpendicular to the inclined plane yields the exact static equilibrium equation....
Q5. Liquid water reaches its maximum density value at__________________?
Show answer Hide answer
Answer: C. 4°C
Liquid water exhibits anomalous thermal expansion behavior, contracting as it warms from melting point until reaching maximum density. The highest density value for pure liquid water occurs precisely at four degrees Cels...
Q6. The assertion that diesel engines exhibit lower specific fuel consumption than petrol engines is classified as____________________?
Show answer Hide answer
Answer: D. true at both part and full load
Diesel engines maintain lower specific fuel consumption than petrol engines across all operating loads. Higher compression ratios and lean burning allow diesels to extract more energy per unit of fuel. This thermodynamic...