Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57512

At atmospheric pressure, dry steam latent heat equals____________________?

Select your answer for: At atmospheric pressure, dry steam latent heat equals____________________?
Show answer

Answer: A. 539 kcal/kg

Explanation

Latent heat of vaporization represents the thermal energy required to convert liquid water into steam at constant pressure. Experimental thermodynamic measurements establish that water requires approximately 539 kilocalories per kilogram at standard pressure. This massive energy absorption explains why steam carries immense thermal capacity for heating and power generation. Atmospheric pressure equals approximately one bar, or 101.3 kilopascals, at sea level under standard weather conditions. Latent heat involves phase change without altering the actual temperature of the boiling water substance. Thermal energy units like kilocalories measure the heat required to raise water temperature or drive phase transitions.

The value 539 BTU per lb uses imperial units rather than the metric kcal/kg standard measurement. The value 427 kg-m/kcal represents the mechanical equivalent of heat rather than the latent heat of water. The value 100 represents the Celsius boiling temperature of water at atmospheric pressure rather than its latent heat.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. Inconel is categorized as an alloy of___________________?

Select your answer for: Inconel is categorized as an alloy of___________________?
Show answer

Answer: A. nickel, chromium and iron

Inconel is categorized as an alloy of nickel, chromium, and iron. Metallurgical compositions of superalloys include high percentages of nickel. Adding chromium and iron provides exceptional resistance to oxidation and co...

Q2. Achieving isothermal compression efficiency requires operating the compressor__________________?

Select your answer for: Achieving isothermal compression efficiency requires operating the compressor__________________?
Show answer

Answer: B. at very slow speed

To allow enough time for heat rejection and approximate an isothermal process, a compressor must run slowly. Running a compressor at very slow speeds keeps gas temperatures from rising during the compression cycle. Therm...

Q3. Large forgings, crankshafts, and axles typically contain carbon up to________________?

Select your answer for: Large forgings, crankshafts, and axles typically contain carbon up to________________?
Show answer

Answer: C. 0.45 to 0.55%

Medium carbon steels used for heavy forgings contain carbon ranging from 0.45 to 0.55 percent. This specific carbon concentration provides a favorable balance of high tensile strength and toughness. Heat treatment proces...

Q4. How does blow-by past piston rings and valve seats in internal combustion engines vary with speed_______________?

Select your answer for: How does blow-by past piston rings and valve seats in internal combustion engines vary with speed_______________?
Show answer

Answer: B. decreases

Higher engine speeds reduce the available time window for gas leakage to occur. Less blow-by volume escapes past piston rings and valve seats during rapid engine cycles. The duration of high pressure exposure per combust...

Q5. A locomotive-type boiler is categorized as__________________?

Select your answer for: A locomotive-type boiler is categorized as__________________?
Show answer

Answer: D. horizontal multi-tubular fire tube type

A locomotive-type boiler is categorized as a horizontal, multi-tubular, fire-tube boiler. Hot combustion gases pass through numerous internal tubes surrounded by water to generate steam. Its horizontal cylindrical shell...

Q6. Backing rings are inserted inside pipe joints when executing___________________?

Select your answer for: Backing rings are inserted inside pipe joints when executing___________________?
Show answer

Answer: A. butt weld

Backing rings are inserted inside pipe joints specifically during butt welding procedures. The ring bridges the root gap to support the molten weld pool during joint fabrication. It prevents weld metal from sagging or pr...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test