Skip to main content
Sarkari MCQs Government Exam Question Bank
Menu
Question no. 57282

Under fan laws, constant-wheel-diameter fans experience pressure variation as________________?

Select your answer for: Under fan laws, constant-wheel-diameter fans experience pressure variation as________________?
Show answer

Answer: B. square of fan speed

Explanation

Fan laws dictate that for a constant impeller wheel diameter, generated pressure varies directly as the square of speed. Doubling the rotational speed of a centrifugal fan increases the resulting pressure rise by a factor of four. This quadratic speed relationship stems from fluid acceleration and centrifugal force equations in turbomachinery. Turbomachinery performance scaling relies on dimensionless similarity parameters and fan affinity laws. Impeller tip speed increases linearly with rotational speed, driving higher dynamic pressure generation. Power consumption for constant wheel diameter fans varies as the cube of the rotational speed.

Variable frequency drives adjust fan motor speeds to control ventilation pressure and airflow in buildings. Engineers use fan laws to predict how increasing fan RPM will affect duct system static pressures. Industrial exhaust systems require careful speed selection because power demands rise rapidly with speed. Varying directly as fan speed describes airflow capacity rather than pressure rise performance. Cube of fan speed describes power consumption scaling rather than the quadratic pressure variation. Square root of fan speed is incorrect because pressure increases quadratically, not sub-linearly, with speed.

Subject
Engineering
Topic
—
Difficulty
medium

Related questions

Q1. According to fan laws, holding pressure constant results in speed, capacity, and power varying_________________?

Select your answer for: According to fan laws, holding pressure constant results in speed, capacity, and power varying_________________?
Show answer

Answer: B. inversely as square root of density

When holding pressure constant, fan speed and capacity vary inversely as the square root of gas density. Changes in ambient air density require speed adjustments to maintain identical static pressure outputs. Aerodynamic...

Q2. Which material demonstrates the highest thermal conductivity________________?

Select your answer for: Which material demonstrates the highest thermal conductivity________________?
Show answer

Answer: D. copper

Copper has the highest thermal conductivity of these metals, at around 400 watts per metre-kelvin. Aluminium follows at roughly 235, then brass, then steel, with lead the poorest. Copper's combination of thermal and elec...

Q3. An axial flow pump should be initiated with its discharge valve________________?

Select your answer for: An axial flow pump should be initiated with its discharge valve________________?
Show answer

Answer: B. kept fully open

Axial flow pumps draw maximum electrical starting torque when their discharge valves are closed. Starting with the discharge valve fully open minimizes starting torque and motor overload. This operational procedure prote...

Q4. Francis turbines are ideally applied for_____________________?

Select your answer for: Francis turbines are ideally applied for_____________________?
Show answer

Answer: A. medium head application from 24 to 180 m

Francis turbines are reaction turbines ideally suited for medium head hydroelectric installations from 24 to 180 meters. Their inward flow runner design efficiently extracts energy from moderate water pressures and flow...

Q5. A centrifugal pump ought to be started with its discharge valve __________________?

Select your answer for: A centrifugal pump ought to be started with its discharge valve __________________?
Show answer

Answer: A. kept fully closed

Centrifugal pumps are started with the discharge valve fully closed to minimize starting torque. Closing the discharge valve reduces the volumetric flow rate to zero, lowering starting power demand. Starting against a cl...

Q6. When starting an axial flow pump, the delivery valve position should be____________________?

Select your answer for: When starting an axial flow pump, the delivery valve position should be____________________?
Show answer

Answer: B. open

Axial flow pump power consumption peaks sharply when the discharge delivery valve is closed. Opening the delivery valve during startup prevents excessive motor current overload conditions. This hydraulic characteristic i...

New!

Mock Test System is now available!

Prepare for your exam with interactive mock tests. Select your subjects, attempt 100 random MCQs against the clock, and see exactly where you stand.

Start Mock Test