Idling speed in a petrol engine requires an approximate air-fuel ratio of_________________?
Show answer Hide answer
Answer: C. 10:1
Explanation
Idling in a petrol engine requires a rich air-fuel ratio to maintain smooth combustion stability. Exhaust gas dilution inside the cylinder at idle demands extra fuel to ensure reliable ignition. Option C correctly identifies the approximate 10:1 air-fuel ratio needed for stable engine idling. Carburetors and fuel injection systems use idle circuits to deliver richer mixtures during zero load. Stoichiometric ratios are around 14.7:1, making 10:1 significantly richer in fuel content. Insufficient fuel during idle leads to engine stalling and rough operational vibration.
Modern electronic engine control units automatically adjust injector pulse widths during vehicle idling. Emissions testing checks idle performance to ensure unburned hydrocarbon levels remain acceptable. Proper idling setup prevents engine stalling when accessories like air conditioning engage. Option A a 1:1 ratio is far too rich and would immediately flood and stall the engine. Option B a 5:1 ratio lacks sufficient oxygen and creates severe operational misfires. Options D and E represent lean or stoichiometric ratios that cause rough idling and stalling.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. What is a standard characteristic of a typical medium-speed 4-stroke cycle diesel engine________________?
Show answer Hide answer
Answer: A. compression starts at 35° after bottom dead center and ends at top dead center
Valve timing in medium-speed four-stroke diesel engines specifies compression starting after bottom dead center. Dynamic ramming effects from incoming air inertia allow compression to begin slightly past bottom dead cent...
Q2. A 75 cc engine designates this specific parameter as 75 cc___________________?
Show answer Hide answer
Answer: C. swept volume
Engine displacement of 75 cc refers explicitly to the total swept volume of the cylinder during piston strokes. Swept volume is calculated by multiplying the cross sectional piston area by the total length of the piston...
Q3. How does the compression ratio of a diesel engine compare to its expansion ratio_______________?
Show answer Hide answer
Answer: C. more
In a diesel engine, fuel cut-off occurs after compression, meaning expansion begins after combustion. The expansion ratio is defined as total cylinder volume divided by volume at the end of combustion cut-off. Because co...
Q4. Diesel fuel injected into a cylinder auto-ignites instantly at compressed air temperatures around____________________?
Show answer Hide answer
Answer: C. 1000°C
Diesel fuel auto-ignites when injected into highly compressed air reaching temperatures around 1000 degrees Celsius. High air temperatures inside the combustion chamber provide the necessary activation energy for spontan...
Q5. Gas turbine fuel consumption guarantees are calculated based on________________?
Show answer Hide answer
Answer: B. low heat value
Gas turbine fuel consumption guarantees are calculated based on the low heat value because exhaust gases remain superheated. Exhaust temperatures in gas turbines are extremely high, preventing any condensation of water v...
Q6. During each cycle, the ignition spark persists for approximately____________________?
Show answer Hide answer
Answer: D. 0.001 sec
The ignition spark in an internal combustion engine is extremely brief, lasting approximately 0.001 seconds. This millisecond-long electrical discharge provides just enough energy to initiate the combustion flame kernel....