Fuel consumption rates within gas turbine engines are primarily dictated by___________________?
Show answer Hide answer
Answer: A. low.er heating value
Explanation
Fuel consumption calculations in gas turbines are based on the lower heating value since exhaust moisture remains in vapor form. Gas turbine exhaust temperatures are extremely high, preventing any condensation of the water vapor generated during combustion. Because the latent heat of vaporization is never recovered, engineers must use the lower heating value for accurate rates. The lower heating value measures the energy released when fuel burns, excluding the latent heat of water vapor. Hydrocarbon fuels contain hydrogen that converts to water during combustion, producing significant amounts of water vapor. Calorimetric testing determines these specific thermal values under controlled laboratory combustion and temperature conditions.
The higher heating value includes the latent heat of vaporization, which assumes all exhaust moisture fully condenses. Higher heating values apply primarily to condensing boilers where exhaust gases are cooled below the water dew point. Generic heating value terms without specification are ambiguous and inadequate for rigorous gas turbine performance calculations.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. How do peak combustion pressures in gas turbines compare against standard internal combustion engines_________________?
Show answer Hide answer
Answer: B. less
Due to continuous flow and turbine material limits peak pressures in gas turbines are generally lower. Reciprocating engines seal the combustion chamber intermittently allowing extreme localized pressure spikes during po...
Q2. Ram-jet reaction engines operate by__________________?
Show answer Hide answer
Answer: B. is not self-operating at zero^flight speed
Ramjet engines rely entirely on high forward flight speed to compress incoming air through forward-facing diffuser inlets. At zero flight speed, the ramjet cannot generate the necessary internal air compression required...
Q3. Indicated work output per unit mass of delivered air represents___________________?
Show answer Hide answer
Answer: C. not affected by clearance volume
Indicated work output per unit mass depends strictly on system pressure limits rather than volume. The clearance volume does not alter the fundamental work calculation per unit mass delivered by the compressor. Theoretic...
Q4. The primary objective of implementing gas turbine reheating is to__________________?
Show answer Hide answer
Answer: C. increase power output
Reheating gas between turbine stages increases the specific power output of the gas turbine system. Injecting additional thermal energy expands the working fluid further and boosts overall turbine work production. This p...
Q5. The maximum temperature zone within a gas turbine plant is located at______________________?
Show answer Hide answer
Answer: D. between ~ to i of the blade height
Thermal and mechanical stress concentrations on gas turbine blades peak slightly inward from the tip region. The combination of centrifugal stress and hot combustion gas flow creates maximum temperature zones between mid...
Q6. Maximum propulsive efficiency for a turbojet aircraft is achieved around what flight velocity__________________?
Show answer Hide answer
Answer: D. 2400km /hr
Maximum propulsive efficiency happens when the exhaust jet velocity matches the forward flight velocity closely. At a flight speed of 2400 kilometers per hour, turbojet engines achieve this optimal velocity ratio. Operat...