Fire tube boilers are characterized by__________________?
Show answer Hide answer
Answer: A. flue gases pass through tubes and water around it
Explanation
In fire tube boilers, hot flue gases pass through the inside of the tubes while water surrounds them. This configuration houses the water and steam within a large outer shell enclosing the internal gas tubes. Heat transfers outward through the tube walls from the hot combustion gases directly into the water. Boilers are classified into fire tube and water tube designs based on fluid routing inside the pressure vessel. Fire tube boilers are historically simpler to construct and handle fluctuating steam demands relatively well. Combustion chambers direct hot flue gases through multiple passes within the submerged tube bundle.
Passing water through tubes with flue gases around them describes the layout of water tube boilers. Forced circulation refers to pump-assisted fluid movement rather than the basic fire tube geometry. Laying tubes vertically is a structural orientation variant rather than the defining feature of fire tube boilers.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Which curve describes a point moving such that its distance from a focal point equals its distance from a directrix multiplied by a constant exceeding one___________________?
Show answer Hide answer
Answer: B. hyperbola
A hyperbola is defined as the locus of a point whose distance from the focus is a constant greater than one times its distance from the directrix (eccentricity > 1). This geometric property sets hyperbolic curves apart f...
Q2. Film boiling takes place at _______________________?
Show answer Hide answer
Answer: D. very high pressures
Film boiling occurs when high surface temperatures or pressures create an insulating vapor blanket over the heater. This continuous vapor film drastically reduces heat transfer efficiency because vapor has a low thermal...
Q3. Multiplying either force of a couple by the couple arm yields_________________?
Show answer Hide answer
Answer: D. moment of the couple
The magnitude of a couple is calculated by multiplying one of the forces by the perpendicular distance between them. This perpendicular distance is known in mechanics as the couple arm. The resulting product yields the p...
Q4. Water flow through a pipe roughly 3 meters across is measured using__________________?
Show answer Hide answer
Answer: D. pitot tube
A pitot tube is commonly used to measure fluid velocity and flow rates in large pipes, such as those approximately 3 meters across. Large-diameter conduits prevent the use of standard inline flow meters, making insertion...
Q5. For a system of forces to remain in equilibrium, it is necessary that they be_________________?
Show answer Hide answer
Answer: C. both A. and B. above
Static equilibrium requires that the vector sum of all forces and the sum of all moments equal zero. For a force system to satisfy these equilibrium conditions, the forces must act within the same plane. Additionally, th...
Q6. Fire tube boilers are restricted to a top design working pressure of ____________________?
Show answer Hide answer
Answer: C. 17 kg/cm2
Fire tube boilers are generally limited to lower working pressures typically up to seventeen kilograms per square centimeter. The large outer cylindrical shell of a fire tube boiler must contain high-pressure steam over...