Axial flow compressors share structural similarities with____________________ ?
Show answer Hide answer
Answer: C. turbine
Explanation
Axial-flow compressors and turbines utilize similar aerodynamic airfoil blade rows mounted along a central shaft. Fluid flows parallel to the axis of rotation in both machine types undergoing pressure and velocity changes. Consequently, both systems share identical structural blade design principles and velocity triangle aerodynamics. Turbomachines convert energy between a rotor and a fluid using dynamic action of rotating airfoil blades. Compressors absorb mechanical shaft work to increase fluid pressure, whereas turbines extract work from expanding gases. Stator and rotor blade cascades are fundamental structural building blocks shared by both compressors and turbines.
Aircraft gas turbine engines house axial compressors and axial turbines on common coaxial drive shafts. Aerodynamic testing facilities evaluate compressor and turbine blade profiles using similar wind tunnel setups. Understanding turbine mechanics directly aids engineers in designing efficient axial compressor staging. Option A centrifugal pumps use radial outflow impellers, differing structurally from axial flow compressors. Option B reciprocating pumps use pistons and valves, lacking the continuous rotating blade geometry of turbines. Option D sliding vane compressors rely on eccentric positive displacement vanes rather than axial airfoils.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. At flight velocities surpassing 3000 km/h, propulsion is more effectively achieved using____________________?
Show answer Hide answer
Answer: B. ram-jet engine
Ram-jet engines lack rotating turbine machinery and rely entirely on high forward speed for air compression. At flight velocities surpassing three thousand kilometers per hour, incoming air ram compression becomes highly...
Q2. Incorporating a regenerator into a gas turbine cycle__________________?
Show answer Hide answer
Answer: A. increases thermal efficiency
A regenerator captures waste heat from high-temperature exhaust gases leaving the turbine. This recovered thermal energy preheats the compressed air before it enters the combustor. Preheating reduces the fuel mass requir...
Q3. Gas turbine engines operate based upon_______________?
Show answer Hide answer
Answer: A. Brayton or Atkinson cycle
Gas turbine engines operate thermodynamically on the closed or open Brayton cycle. Brayton cycle processes include isentropic compression and isobaric heat addition steps. Expansion through turbine blades extracts work t...
Q4. Within an irreversible gas turbine loop, both cycle efficiency and work ratio are functions of___________________?
Show answer Hide answer
Answer: D. both pressure ratio and maximum cycle temperature
In an irreversible gas turbine loop, internal friction and heat losses affect overall thermal performance. Cycle efficiency and work ratio depend mathematically on both the compressor pressure ratio and maximum temperatu...
Q5. Gas turbines dedicated to stationary electrical generation are typically deployed___________________?
Show answer Hide answer
Answer: B. to supply peak load requirements
Gas turbines can start up and synchronize with electrical grids in minutes. Rapid response capabilities make them ideal for covering sudden electricity demand spikes. Their low capital cost per peak kilowatt offsets thei...
Q6. Gas turbines operate on lean mixtures requiring high air-fuel ratios because______________________?
Show answer Hide answer
Answer: D. to reduce the exit temperature
Gas turbines operate on lean mixtures with high air-fuel ratios for thermal protection. Excess air mixes with combustion gases to lower temperatures entering turbine blading. Lowering exit temperatures prevents metallurg...