What is the alternative designation for a Static Induction Thyristor (SITH)___________?
Show answer Hide answer
Answer: A. Filled controlled diode
Explanation
A static induction thyristor operates with a vertical semiconductor structure often functionally described as a field controlled diode. The gate terminal controls the potential barrier within the channel, regulating the main carrier flow like a field effect device. This unique operational characteristic gives rise to its alternative designation as a field controlled diode in power electronics. Static induction thyristors are high speed, high voltage semiconductor devices capable of handling substantial power levels. Field controlled devices utilize electrostatic fields to modulate the internal conductivity of the semiconductor drift region. Vertical channel designs reduce on-state resistance and enhance the high frequency switching performance of the device.
Filled controlled rectifier is an incorrect terminology that misstates the fundamental operating principles of static induction devices. Silicon controlled rectifier refers to standard thyristors rather than the specialized field controlled static induction variant. None of these is incorrect because option A provides the recognized alternative designation for this specific device.
- Subject
- Engineering
- Category
- Electrical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Under what specific load conditions is load commutation achievable in a single-phase full bridge inverter____________?
Show answer Hide answer
Answer: B. RLC underdamped.
Load commutation in a single phase full bridge inverter requires an underdamped resistance inductance capacitance load network. The underdamped resonant circuit characteristics allow the load current to naturally cross z...
Q2. What consequences arise from excessively high modulation indices (exceeding 3.24)___________?
Show answer Hide answer
Answer: A. Square AC output voltage
Extremely high modulation indices in pulse-width modulation controllers push pulse patterns. This pushes the switching duty cycles until the output waveform approaches saturation. Consequently, the resulting output volta...
Q3. A single-phase one-pulse controlled circuit has a load consisting of R and counter emf E, with a source voltage of 400 sin(314 t). For a load counter emf of 200 V, what is the firing angle control range_____?
Show answer Hide answer
Answer: A. 30° to 150°.
With a counter electromotive force of two hundred volts and a four hundred volt peak sinusoidal source, firing limits apply. The trigonometric relationship between the source voltage and the counter electromotive force c...
Q4. What is the typical range of the on-state voltage drop across a conducting SCR_____________?
Show answer Hide answer
Answer: C. 1 – 1.5 V.
When a silicon controlled rectifier is fully conducting, the typical forward on state voltage drop is very consistent. Experimental measurements confirm that this forward voltage drop across its terminals typically range...
Q5. Which statement correctly describes the latching current ___________?
Show answer Hide answer
Answer: C. It is related to turn on process of the device.
The latching current is the minimum anode current required immediately after turn-on. It ensures the internal regenerative action sustains conduction once the gate signal is removed. Without reaching this threshold curre...
Q6. How does the emitter radiation field behave in radiative coupling_____________?
Show answer Hide answer
Answer: A. Decays as 1 / R, where R is the separation distance between the emitter and the receptor
In radiative electromagnetic coupling, the far field radiation intensity typically decays inversely proportional to the separation distance. This means the field strength decreases as one over the separation distance bet...