Pick the correct statement from the following choices?
Show answer Hide answer
Answer: D. All the above
Explanation
The definitions for yield moment, plastic moment, and the equal-area neutral axis position in a fully plastic beam are all accurate. Yield moment marks the exact load stage where extreme outer fibers reach initial material yield stress. Plastic moment represents the ultimate capacity when the entire cross-section undergoes plastic deformation. Yield moment initiates the transition from linear elastic behavior into elasto-plastic structural bending. Plastic moment creates a fully yielded cross-section where the neutral axis divides the area into two equal halves. Equal area division ensures internal tensile and compressive plastic forces balance perfectly at collapse.
Plastic design methods allow structural engineers to utilize post-yield reserve strength in steel building frames. Understanding yield and plastic moments prevents unexpected structural collapse under extreme overload conditions. Modern seismic design codes rely heavily on plastic hinge formation concepts to dissipate earthquake energy. Option A describes only the yield moment milestone without covering full plastic moment capacities. Option B defines the plastic moment capacity but omits initial yield and neutral axis area properties. Option C focuses exclusively on the neutral axis location without explaining moment milestone definitions.
- Subject
- Engineering
- Category
- Civil Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Identify the correct assertion among the following?
Show answer Hide answer
Answer: D. All the above
All listed fundamental assertions regarding bending moment of inertia, stress states, and uniaxial behavior are correct. Moments of inertia must always be calculated about the specific axis where bending rotation actuall...
Q2. Select the correct statement from those listed below?
Show answer Hide answer
Answer: D. All the above
The correct answer validates all listed expressions concerning hoop strain, longitudinal strain, and volumetric change in thin cylinders. Internal fluid pressure in thin-walled cylinders generates orthogonal tensile stre...
Q3. Elastic limit failure prediction based on maximum strain is designated as_______________?
Show answer Hide answer
Answer: B. St. Venant’s theory
St. Venant theory establishes elastic limit failure based on the maximum principal strain criterion. This theory posits that yielding occurs when the maximum principal strain reaches the strain corresponding to yield in...
Q4. Select the correct statement from the given set?
Show answer Hide answer
Answer: D. All the above
The correct answer validates all listed statements regarding bending stress and shear stress distributions across beam sections. Bending stress varies linearly from zero at the neutral axis to maximum values at the extre...
Q5. Choose the correct statement amongst the following?
Show answer Hide answer
Answer: D. All the above
Properties of the shear center relative to cross-sectional centroids for channels, I-sections, and generic beams are correctly described. For channel sections, asymmetric geometry causes the shear center to lie outside t...
Q6. Pick out the correct statement from the following?
Show answer Hide answer
Answer: D. All the above
The correct answer confirms that all listed statements regarding shear force and bending moment curve shapes are correct. Uniformly distributed loads produce linear shear force diagrams and parabolic bending moment curve...