How much physical footprint does a steam power station necessitate______________?
Show answer Hide answer
Answer: B. more than diesel power station
Explanation
Steam power stations require extensive land area for boilers, turbines, condensers, and coal storage. This massive infrastructure footprint is significantly larger than compact diesel power stations. Therefore, steam power stations necessitate considerably more physical footprint than diesel plants. Steam power plants utilize large boilers to generate high pressure steam continuously. Auxiliary systems like coal yards and cooling towers occupy huge plots of ground. Diesel generators are compact and need only minimal space for fuel and engines.
Engineers must evaluate space availability before selecting a thermal power plant design. Urban areas often favor diesel generators because of their extremely small physical footprint. Large rural parcels are typically acquired to accommodate expansive steam power stations. Diesel power stations take up much less space than large coal steam stations. Assuming equal footprints ignores the massive auxiliary equipment required by steam cycles. Saying they need less space directly contradicts established power plant engineering principles.
- Subject
- Engineering
- Category
- Electrical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. What impedance level does a voltage clamping device present during an over-voltage event__________?
Show answer Hide answer
Answer: A. low
During an over-voltage event, a voltage clamping device abruptly switches states. It presents a low impedance path to shunt excess energy away from protected components. This low resistance path absorbs transient energy...
Q2. Where is unipolar modulation predominantly applied____________?
Show answer Hide answer
Answer: D. DC – DC converters
Unipolar pulse width modulation techniques are predominantly utilized in dc to dc converters and select single phase inverters. In this modulation scheme the output voltage switches between zero and one specific polarity...
Q3. A thyristor string consisting of series and parallel SCRs handles 11 KV and 4 KA. Given individual SCR ratings of 1800 V and 1000 A with 90% string efficiency, let a and b represent the number of series and parallel units. What are their values_____________?
Show answer Hide answer
Answer: C. 7, 5
Applying string calculations with efficiency factors for eleven kilovolt requirements yields units. Series unit counts are determined by dividing total voltage by individual device ratings. Calculations for this configur...
Q4. An SCR with an inductive load has a 20 µs turn-on time. Given a 2.5 KHz pulse train frequency and a 1/10 mark-to-space ratio, how will the SCR behave___________?
Show answer Hide answer
Answer: A. Turn on
Given the pulse train parameters and turn-on time constraints, the gate pulses provide sufficient energy. The silicon controlled rectifier will successfully latch and transition into a conducting state. Therefore, the de...
Q5. What performance metric evaluates a rectifier circuit by comparing its DC output power to transformer rating, and how is it defined_______________?
Show answer Hide answer
Answer: C. DC output power to the transformer volt – amp rating required by secondary
Transformer utilization factor compares the total direct current output power to the transformer secondary volt ampere rating. This metric evaluates how effectively the transformer capacity is utilized by the connected r...
Q6. What components comprise the annual operating expenses of a power generation facility_________?
Show answer Hide answer
Answer: D. all of the above
Annual operating expenses for a power station include fixed charges, semi-fixed charges, and running charges. All these categories comprehensively cover the total financial cost of generating electricity. Therefore, all...