Crankcase scavenging systems generate air pressure by_________________?
Show answer Hide answer
Answer: D. movement of engine piston
Explanation
Crankcase scavenging two-stroke engines use the downward piston stroke to compress air in the crankcase. This compressed crankcase air is then transferred to the cylinder to push out exhaust gases. Option D correctly identifies movement of the engine piston as the air pressure generator. Two-stroke engines complete power cycles in two piston movements instead of four separate strokes. Crankcase compression eliminates the need for separate superchargers in small two-stroke designs. Sealing the crankcase is critical for maintaining adequate scavenging pressure in these engines.
Small two-stroke petrol engines in lawnmowers and chainsaws rely on crankcase scavenging. Marine two-stroke diesel engines often use underside piston scavenging or separate blowers. Understanding scavenging mechanics helps engineers improve two-stroke volumetric efficiency. Option A superchargers are external blowers not typically used in basic crankcase scavenging. Option B centrifugal pumps are external devices rather than internal crankcase mechanisms. Options C and E are incorrect because piston motion alone creates the crankcase air pressure.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Diesel fuel injected into a cylinder auto-ignites instantly at compressed air temperatures around____________________?
Show answer Hide answer
Answer: C. 1000°C
Diesel fuel auto-ignites when injected into highly compressed air reaching temperatures around 1000 degrees Celsius. High air temperatures inside the combustion chamber provide the necessary activation energy for spontan...
Q2. Gas turbine fuel consumption guarantees are calculated based on________________?
Show answer Hide answer
Answer: B. low heat value
Gas turbine fuel consumption guarantees are calculated based on the low heat value because exhaust gases remain superheated. Exhaust temperatures in gas turbines are extremely high, preventing any condensation of water v...
Q3. During each cycle, the ignition spark persists for approximately____________________?
Show answer Hide answer
Answer: D. 0.001 sec
The ignition spark in an internal combustion engine is extremely brief, lasting approximately 0.001 seconds. This millisecond-long electrical discharge provides just enough energy to initiate the combustion flame kernel....
Q4. In a typical medium-speed 4-stroke cycle diesel engine_______________?
Show answer Hide answer
Answer: A. exhaust valve opens at 35° before bot-tom dead center and closes at 20° after top dead center
Standard valve timing for medium-speed four-stroke diesel engines opens the exhaust valve before bottom dead center. Opening early allows cylinder pressure to blow down spontaneously before the piston begins upward exhau...
Q5. Lowering intake air temperature in internal combustion engines causes efficiency to_______________________?
Show answer Hide answer
Answer: A. increase
Lowering intake air temperature increases air density, which directly improves the volumetric efficiency of the engine. Denser air packs more oxygen into the combustion chamber, allowing more fuel to burn efficiently dur...
Q6. Scavenging processes are executed primarily to enhance__________________?
Show answer Hide answer
Answer: C. power output
Scavenging processes are executed in two-stroke engines primarily to enhance overall power output. Removing burnt exhaust gases and replacing them with fresh air maximizes the trapped mass for combustion. Efficient scave...