Compared to fire tube boilers, water tube boilers generate steam that_________________?
Show answer Hide answer
Answer: A. can be raised rapidly
Explanation
Water tube boilers contain water inside small tubes surrounded by hot combustion gases. Small water volumes inside heated tubes allow steam to be raised rapidly. Large heating surface areas enable rapid thermal response compared to fire tube designs. Water tube boilers circulate water through tubes with hot gases flowing outside. Fire tube boilers pass hot combustion gases through tubes submerged inside a large water shell. Water tube designs handle high operating pressures much safer than fire tube shells.
Power generation plants use water tube boilers to start up and generate steam rapidly. Industrial facilities requiring high-pressure steam choose water tube boilers for safety. Rapid steam generation capabilities meet fluctuating industrial process steam demands efficiently. Is raised at slower rate describes fire tube boilers due to their large water volume. Is raised at same rate ignores the fundamental heat transfer design differences. Depending on design is incorrect because water tube physics inherently allow rapid steaming.
- Subject
- Engineering
- Category
- Mechanical Engineering
- Topic
- —
- Difficulty
- medium
Related questions
Q1. Standard air is defined as atmospheric air at_____________________?
Show answer Hide answer
Answer: B. 20°C and 1 kg/cm2 and relative humidity 36%
Standard air is conventionally defined in industrial engineering at specific reference conditions including temperature and humidity. These standardized parameters include a temperature of twenty degrees Celsius, one kil...
Q2. The gradual, time-dependent plastic yielding of metallic materials under steady stress is known as________________?
Show answer Hide answer
Answer: A. creep
Creep is the slow, time-dependent permanent deformation of materials subjected to a constant mechanical stress over a long period. Metals operating at high temperatures experience atomic dislocation movement that gradual...
Q3. Where does the net liquid pressure force act on a fully submerged body____________________?
Show answer Hide answer
Answer: B. centre of pressure
The net hydrostatic pressure force on a fully submerged body acts through the center of pressure. Integrating distributed fluid pressure forces across a submerged surface yields a single resultant force acting at the cen...
Q4. In SI units, the specific weight of water is equal to ________________?
Show answer Hide answer
Answer: C. 9.81 xlO3 N/m3
The specific weight of a fluid is calculated by multiplying its mass density by gravitational acceleration. For water, the standard density is approximately one thousand kilograms per cubic meter. Multiplying one thousan...
Q5. Where does structural failure occur when a cantilever beam's end load is increased___________________?
Show answer Hide answer
Answer: D. anywhere
Structural failure in a loaded cantilever beam can occur anywhere along its span where the bending moment exceeds the material's capacity. While maximum bending moment concentrates at the fixed support, material defects...
Q6. What are the desired characteristics of a refrigerator refrigerant___________________?
Show answer Hide answer
Answer: C. high latent heat
A high latent heat of vaporization allows refrigerants to absorb massive quantities of thermal energy during phase change. Refrigeration systems depend on phase change enthalpy rather than sensible temperature changes to...